Clarion UNGO PRO SECURITY K20 Kurulum Kılavuzu - Sayfa 11
Araba Alarmı Clarion UNGO PRO SECURITY K20 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Clarion UNGO PRO SECURITY K20 14 sayfaları. Clarion k20 cctv systems: installation guide
Ayrıca Clarion UNGO PRO SECURITY K20 için: Kullanıcı El Kitabı (19 sayfalar)
Sayfayı Yazdır
Transmitter/Receiver Learn Routine
The system comes with two transmitters that have been taught to the receiver. The receiver can store up to four different transmitter codes in
memory. Use the following learn routine to add transmitters to the system or to change button assignments if desired.
1.
K K e e y y . . Turn the key to the ON position.
2.
C C h h o o o o s s e e . . Within 10 seconds, press and release the Valet/program switch the number of times corresponding to the
desired channel listed below. Once you have selected the channel, press the switch once more and HOLD it. The LED
will flash and the horn will honk ( if connected) to confirm the selected channel. Do not release the Valet/program
switch.
3.
T T r r a a n n s s m m i i t t . . While holding the Valet/Program button, press the button from the transmitter that you wish to assign to
the selected channel. The horn will honk (if connected) indicating successful programming. It is not possible to teach
a transmitter button to the system more than once.
4.
R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program button can be released.
Channel Number
1
2
3
4
5
6
7
8
**NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
C C h h a a n n n n e e l l # # 8 8 : : If any button from a known transmitter is programmed to Channel 8, all transmitters will be erased from memory and the system
features will revert to the default settings. This is useful in cases where the one of the customer's transmitters is lost or stolen. This will erase any
lost or stolen transmitters from the system's memory. It can also be used to start from scratch if the transmitter buttons were programmed incor-
rectly.
To exit the learn routine:
One long horn honk (if connected) indicates that Learn Routine has been exited.
➤ ➤
Ignition is turned off.
Valet/Program button is pressed too many times.
➤
➤ ➤
More than 15 seconds elapse between steps.
Function
Auto Learn
Arm only
Disarm only
Channel 2
Channel 3
Arm/Disarm/Panic
Panic Only
Delete all transmitters
Wire Color
RED/WHITE
WHITE/BLUE
11