Xerox 3400N - Phaser B/W Laser Printer Ağ Kılavuzu - Sayfa 10

Yazıcı Xerox 3400N - Phaser B/W Laser Printer için çevrimiçi göz atın veya pdf Ağ Kılavuzu indirin. Xerox 3400N - Phaser B/W Laser Printer 21 sayfaları. Network guide
Ayrıca Xerox 3400N - Phaser B/W Laser Printer için: Broşür (4 sayfalar)

Sayfayı Yazdır
TCP/IP Configuration
1.
Install the driver as described on page 4.
2.
Click Start, select Setting, and then click Printers.
3.
Right-click on the Phaser 3400 printer and click Properties from the popup menu.
4.
On the Details tab, click the Add Port button.
5.
Verify that Network is the port that is selected.
6.
Either manually type in the network path or select it as follows:
a.
Click the Browse button.
b.
Double-click the server to which the printer is attached.
c.
Select the Phaser 3400 printer (or the share name that was designated by the
network administrator).
d.
Click the OK button.
Note
If you are not sure which server the Phaser 3400 printer is attached to or if the
Phaser 3400 printer is not selectable on the server, contact your network
administrator for support.
7.
When the network portion of the Add Port dialog box shows the path, click the OK
button.
8.
The Details tab should now display the network path for Print to the Following Port.
Click the Apply button.
9.
When you see the Fonts Downloaded to this printer while connected to LPT1 may be
lost message, click the OK button. You may need to resend the fonts again on \\your
server name\your printer name.
10.
On the General tab, click the Print Test Page button.

Macintosh

Setting up the Macintosh Ethernet port for TCP/IP
When using OS 8.5 or higher, you can use TCP/IP to print from your Macintosh. If your
Macintosh is not already set up for TCP/IP, perform the following procedure:
1.
From the Apple menu, select Control Panels, and select TCP/IP.
2.
From the Connect via menu, select Ethernet.
3.
Specify how the Macintosh will obtain its IP address: Manually or by DHCP.
If you select Manually, specify the IP address in the dialog box.
4.
5.
Close the dialog box and click Save for changes to take effect.
6
Phaser 3400 Personal Laser Printer