Xerox 721 Operatör El Kitabı - Sayfa 9

Yazıcı Xerox 721 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Xerox 721 11 sayfaları. Software tools
Ayrıca Xerox 721 için: Kurulum Kılavuzu (20 sayfalar), Yayın Notu (23 sayfalar), Yayın Notu (8 sayfalar), Müşteri Eğitim Kılavuzu (50 sayfalar)

Sayfayı Yazdır

Location of the Stacker Serial Number

In order to locate the serial number of your stacker, you must first

push down the release lever and slide the stacker away from the

printer.

The serial number plate is located on the left of the front cover facing

the printer.

Serial Number Plate

Figure 1. Sliding the Stacker away from the Printer.

Stacker Operation

If you are running paper larger than a 24" (610mm) raise the paper

supports.

In order to turn on your stacker, press the power switch to the on

position. When the stacker is on the green Power Indicator Light is

visible.

NOTE: There is no start up sequence between the stacker and the

printer (either the stacker or the printer may be turned on first). If

your stacker does not run, turn off both the printer and the stacker.

Turn on the stacker then turn on the printer. If the stacker still does

not function, verify power source and then call for service.

Stacker Jam Clearance

The paper fed from the printer will be either cut or uncut.

Caution

To ensure the safety of the user, be aware during jam

clearance that the surface will be hot.

Cut

In order to clear a jam in the stacker, lift the Upper Panel Assembly

and clear any paper (Figure 2). If the jam still exists, push down on

the release lever and move the stacker away from the printer (Figure

1). Clear any visible paper from the paper path.

Uncut

Cut the paper in the printer (refer to the printer user guide) and follow

the above procedure.

Caution Hot Label

Jam Clearance Label

Figure 2. Lifting the Upper Panel Assembly.

NOTE; The Transmission PWB and the Reception PWB are infrared

connections (See Identifying the Parts on the Stacker). To ensure

proper operation of the stacker, these connections must be debris

free.

Upper Panel Assembly