Xerox 4150X - WorkCentre B/W Laser Başlangıç Kılavuzu - Sayfa 13

Hepsi Bir Arada Yazıcı Xerox 4150X - WorkCentre B/W Laser için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Xerox 4150X - WorkCentre B/W Laser 38 sayfaları. Finisher installation guide
Ayrıca Xerox 4150X - WorkCentre B/W Laser için: Broşür ve Teknik Özellikler (4 sayfalar), Hızlı Referans (1 sayfalar), Kartuşların Değiştirilmesi (1 sayfalar), Kurulum Talimatları Kılavuzu (40 sayfalar), Modül Kurulum Kılavuzu (1 sayfalar), Donanım Kurulum Kılavuzu (1 sayfalar), Tepsi Modülü Kurulum Kılavuzu (1 sayfalar), Modül Kurulum Kılavuzu (1 sayfalar), Kurulum Kılavuzu (6 sayfalar)

Sayfayı Yazdır
Xerox 4150X - WorkCentre B/W Laser Başlangıç Kılavuzu

Connecting to the Network

If your WorkCentre is a 4150s, 4150x or 4150xf, follow these instructions to connect the
WorkCentre to an Ethernet TCP/IP network.
If you are connecting your WorkCentre to a different type of network, or you wish to use
other protocols, refer to the System Administration CD.
Test the WorkCentre
Before connecting the WorkCentre to your network, make sure that it is operating correctly
as a copier.
1
Place a document in the Document Feeder and make 3 copies.
2
If the copies are made successfully, install the network connection as described in the next
steps. If copying is not successful, refer to Troubleshooting on page 31.
Network Connection using TCP/IP
You can set up the TCP/IP network connection using either of the following methods:
• DHCP: Use this method to allow a DHCP server to automatically assign an IP address.
This is the factory default setting.
• Static IP address: Use this method to manually assign an IP address provided by the
network administrator.
When the WorkCentre is powered on, it automatically uses DHCP to obtain its network
configuration. To use a static IP address, DHCP must be turned off and the IP address,
gateway address, subnet mask, and DNS Server address must be entered manually.
1
Connect the Ethernet cable to the RJ45 connector
on the WorkCentre.
NOTE:
The Ethernet cable is not supplied by Xerox.
2
Continue on to the next step to setup the address
using DHCP. If you want to set a static IP address,
skip to Network Setup Using a Static IP Address on
page 10.
Network Setup Using DHCP
1
After the WorkCentre starts, it negotiates with the DHCP server for an IP address. Wait two
minutes for the network setup to complete and then check the allocated IP address as
follows:
• On the Control Panel, select the Access button and then enter the Administrator
passcode [1111] and select Enter.
• Select Go to Tools > Connectivity and Network Setup > Network Setup > TCP/
IP Options > TCP/IP Settings.
• The allocated TCP/IP address is in the Name/Address field.
getting started guide
RJ45
Network
Connector
9