Xerox 460 Hızlı Kurulum Kılavuzu - Sayfa 37

Hepsi Bir Arada Yazıcı Xerox 460 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Xerox 460 38 sayfaları. Macintosh driver information
Ayrıca Xerox 460 için: Bilgi Kılavuzu (13 sayfalar)

Sayfayı Yazdır
Xerox 460 Hızlı Kurulum Kılavuzu
Port 9100 TCP/IP Printing Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
Your Document Centre has DHCP enabled by
default. If your DHCP server is configured with
the TCP/IP information for the Document
Centre, you should Skip Steps 5 and 6 on this
card and go to Step 7 to enable Port 9100
printing. If you wish toconfigure your TCP/IP
information statically, complete ALL Steps on
this card.
Your Document Centre supports printing from a
variety of operating systems that support TCP/IP
and now supports Port 9100 (RAW) printing.
Record the following information assigned to
your Document Centre:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre to the net-
work with the appropriate cabling.
2.
Enter the Tools pathway.
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
Page 1
4.
Enable the network interface and protocol.
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
5.
Set the Host Name.
a)
Press the Name/Address button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
IP address and enter the numbers
using the keypad.
c)
Press the Host Name button.
d)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.