Xerox DC230LP Hızlı Kurulum - Sayfa 2
Hepsi Bir Arada Yazıcı Xerox DC230LP için çevrimiçi göz atın veya pdf Hızlı Kurulum indirin. Xerox DC230LP 4 sayfaları. Windows nt 4.0 tcp/ip
Sayfayı Yazdır
RARP
b)
Press [
].
(current entry)
c)
Press [ ] until the required setting
RARP
=
displays
(required entry)
d)
Press [Enter]. **SAVED** displays
momentarily, followed by
>
RARP
.
(your entry)
6.
Enter the Gateway Address:
Default Gateway
a)
Press [ ] until
(current entry)
displays.
Default Gateway =
b)
Press [
].
(current entry)
Note: Use zeros to supplement each address
segment if fewer than 3 digits are used; e.g.,
13.252.25.08 = 013.252.025.008.
c)
Use the [ ] or [ ] key to select the
first digit in the Gateway Address.
d)
Press [
] to move to the next digit.
Repeat this procedure to enter the
entire Gateway Address.
DC230LP Windows NT
e)
Press [Enter]. **SAVED** displays
=
displays.
*
momentarily, followed by
Default Gateway
(your entry)
.
7.
Enter the Subnet Mask:
a)
Press [ ] until
displays.
b)
Press [
c)
Use the [ ] or [ ] key to select the
>
first digit of the Subnet Mask for your
network.
d)
Press [
displays.
Repeat this procedure to enter the
entire Subnet Mask.
e)
Press [Enter]. **SAVED** displays
momentarily, followed by
Subnet Mask
(your entry)
8.
Enter the Broadcast Address:
Note: Broadcast Address is where all the host
bits are set to either zeros (0) or ones (1).
®
4.0 TCP/IP Quick Install
>
.
>
Subnet Mask
(current entry)
Subnet Mask
=
].
displays.
(current entry)
] to move to the next digit.
>
.
Page 2 of 4
Broadcast Addr
a)
Press [ ] until
(current entry)
displays.
Broadcast Addr =
b)
Press [
].
(current entry)
c)
Use the [ ] or [ ] key to select the
first digit in the Broadcast Address.
d)
Press [
] to move to the next digit.
Repeat procedure to enter the entire
Broadcast Address.
e)
Press [Enter]. **SAVED** displays
momentarily, followed by
>
Broadcast Addr
.
(your entry)
9.
Enter the Printer (Host) Name:
Note: It is recommended that the Printer (Host)
Name be the same as your Share Name.
Printer Name
a)
Press [ ] until
(current entry)
displays.
Printer Name
b)
Press [
].
(current entry)
c)
Press [
] repeatedly until the cursor
reaches the last character. A tone
sounds indicating when the last
character has been reached.
>
displays.
>
=
displays.