Xerox DocuColor 250 Yayın Notu - Sayfa 26

Hepsi Bir Arada Yazıcı Xerox DocuColor 250 için çevrimiçi göz atın veya pdf Yayın Notu indirin. Xerox DocuColor 250 34 sayfaları. Printer-copier
Ayrıca Xerox DocuColor 250 için: Hızlı Başlangıç Kılavuzu (47 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Kullanım Kılavuzu (2 sayfalar), Ayarlar Kılavuzu (6 sayfalar), Kopyalama İçin Kitapçık Oluşturma (2 sayfalar), Sistem Ayarları Listesi (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Değerlendirici El Kitabı (20 sayfalar), Değerlendirici El Kitabı (18 sayfalar)

Sayfayı Yazdır
Xerox DocuColor 250 Yayın Notu
Command
WorkStation
Job Size
Command WorkStation displays job size in kilobytes, regardless of the size of the file.
Other tools may show job size in megabytes or kilobytes.
Job Log
Save and clear the Job Log regularly. After the Job Log accumulates a large number of
entries (approximately 16,000 jobs), the Fiery stops responding when you start Command
WorkStation.
Activity Monitor
When you print more than one copy of a job, the Activity Monitor reports that Copy 2 is
printing, and then Copy 2, Copy 3, Copy 4, and so on. Although the Activity Monitor
does not start counting with Copy 1, the correct number of copies prints.
Available memory
The General Info section displays the amount of memory available for Command
WorkStation and other Fiery software, whereas the Configuration page displays the amount
of memory available for Command WorkStation, other Fiery software, and the Fiery system
software.
The "Memory 100%" displayed in the upper-right corner of the copier display is the
copier memory. The memory bar in Command WorkStation is the Fiery memory.
Combine Separations
If you send a job with Combine Separations set to On, you may see an error message in
Command WorkStation. To avoid the error message, set Combine Separations to
Printer's default or Off, or send a Separations job.
Image Shift units in Job Properties
When the Job Properties format is set to Simple Table Style Format, you cannot select the
units for the Image Shift settings. The units are always 1/100 of a point. To select the units
(mm, inches or points), change the Job Properties format (in Preferences) to Driver Overrides
Format.
File formats for downloading
You can import or download only files of the following formats to the Fiery using Command
WorkStation, Downloader, or WebDownloader: PostScript (PS), EPS, TIFF, PDF, PCL, PJL
and text. Downloading files of unsupported formats results in an error message or an unusable
printout.
Page 26
Part Number: 45045321