Xerox Document Centre 230 Hızlı Kurulum Kılavuzu - Sayfa 3

Hepsi Bir Arada Yazıcı Xerox Document Centre 230 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Xerox Document Centre 230 8 sayfaları. Xerox document centre 230: install guide
Ayrıca Xerox Document Centre 230 için: Hızlı Kurulum (1 sayfalar), Taramaya Genel Bakış (2 sayfalar), Başlarken (48 sayfalar), Kurulum Kılavuzu (2 sayfalar)

Sayfayı Yazdır
Xerox Document Centre 230 Hızlı Kurulum Kılavuzu
DC220/230/332/340ST NetWare

Installation Requirements:

•
Be sure that the DC220/230/332/340ST is
connected, configured and operational as a
Network Printer with NetWare enabled and
the correct Frame Type selected before
performing this procedure.
•
The DC220/230/332/340ST Scan to File
option kit must be installed before
performing this procedure.
•
Create a user account for the DC220/230/
332/340ST. Use SYSCON for NetWare 3.1x,
or NWADMIN for NetWare 4.1x/IntraNet-
Ware Bindery to create an account on the
file server for the DC220/230/332/340ST
with all access rights to the document
Repository except supervisor.

Before Installation:

Please review the DC220/230/332/340ST
Scanning Overview card before proceeding.
Record the following information for use during
setup at the DC220/230/332/340ST:
Scan User Name:________________________
Scan User Password:_____________________
File Repository Server:____________________
For assistance, contact your local Xerox Customer Support Center
602E60390
7KH 'RFXPHQW &RPSDQ\
;(52;
®
3.1x/4.1x Bindery Scan to File Quick Install
Repository Directory:_____________________
1.
Enter System Administrator Setups:
a)
Press the [Access] button on the
Control Panel.
b)
Enter the System Administrator
#22222
password by typing
and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
and may be changed by your Xerox
service representative to suit your
needs.
2.
Access the Scan to File Setups screens
and assign the Default Repository Server:
a)
On the screen display, press [Scan to
File Setups].
b)
Press [Default Repository].
Note: The Job Template Pool and Update All
Templates options on this screen are not used in
this environment.
c)
Press [Netware].
Page 1 of 2
d)
Press [Server].
e)
Press [Edit] and use the keyboard on
the screen to enter the name of the file
server.
f)
Press [Save].
3.
Assign the Default Repository Path:
(# key
a)
Press [Directory Path].
b)
Press [Edit] and use the keyboard on
the screen to enter the path.
Be sure to enter the full path,
including the volume name, to the
DC220/230/332/340ST account
directory
Example: vol1:\users\scan.
c)
Press [Save].
4.
For a Bindery installation, set the NDS
Tree and NDS Context to a dash:
a)
Press [NDS Tree].
b)
Press [Edit] and use the keyboard on
the screen to enter a [-] dash.
Over