ipaddress—Specifies the IP address assigned to the color server. This parameter is
required. If dhcp_client is set to yes and no DHCP services are found on the network, the
specified IP address is used. The default value for ipaddress is 192.168.0.254.
subnetmask—Specifies the subnetmask assigned to the color server. This parameter is
required. If dhcp_client is set to yes and no DHCP services are found on the network, the
specified subnet mask is used. The default value for subnetmask is 255.255.255.0.
defaultgateway0—Specifies the permanent IP address assigned to the gateway or router.
This parameter is ignored if there is no value after the equal sign (=), which is the default.
nameserver0—Specifies the permanent IP address assigned to the gateway or router.
This parameter is ignored if there is no value after the equal sign (=), which is the default.
workgroup—Specifies the Windows domain or Windows Workgroup to which the color
server belongs. The name can be up to 15 characters long. Valid values are alphanumeric
characters and underscores. The name cannot include spaces or periods. If the network
does not use Windows domains or Workgroups, leave this parameter blank (default).
nt_domain_controller—Specifies the IP address of the NT domain controller for the color
server. If an NT domain controller does not exist, leave this parameter blank (default).
wins_server—Specifies the IP address of the WINS server for the color server. If a WINS
server does not exists, leave this parameter blank (default).
zone—Specifies the name of the AppleTalk zone that the color server uses for Macintosh
printing. The name can contain up to 32 characters. Valid values are alphanumeric char-
acters, underscores, spaces, and periods. If Macintosh workstations are not printing to the
color server, leave this parameter blank (default).
The DP.INI file contains two sections of parameters called Printer 0 and Printer 1: one section
for configuring the color server print queue and the other for configuring the color server hold
queue. Each section contains the following parameters, where # can equal either 0
(parameters in Printer 0 section) or 1 (parameters in Printer 1 section):
pq#—Specifies the color server printer name that is used for lpd queue, Windows printer
sharename, and AppleTalk LaserWriter name. Valid values are alphanumeric characters
and underscores. The name cannot include spaces or periods. The default value for
Printer 0 is Splash_print. The default value for Printer 1 is Splash_hold.
pq#device—Specifies the copier to which the color server is connected. Valid values are
5750 (DocuColor
pq0device and pq1device must be identical.
pq#type—Specifies the type of queue: print or hold. Valid values are PRINT (print queue),
and HOLD (hold queue).
pq#wintcp—Enables/disables the color server support for TCP/IP protocol. Valid values
are on (enable support) and off (disable support). The default value is on.
pq#ethertalk—Enables/disables the color server support for AppleTalk protocol. Valid val-
ues are on (enable support) and off (disable support). The default value is on.
0015647-0001 February 18, 1999
5750), 5790, and 5799 (DocuColor
TM
Getting Started Guide
5799). Note that the values for
TM
page-7
Sayfayı Yazdır