Xerox DocuPrint C55 Yükseltme Kılavuzu

Fotokopi Makinesi Xerox DocuPrint C55 için çevrimiçi göz atın veya pdf Yükseltme Kılavuzu indirin. Xerox DocuPrint C55 1 sayfaları. Xerox copier user manual
Ayrıca Xerox DocuPrint C55 için: Broşür (2 sayfalar)

Sayfayı Yazdır

CopyCentre C35/C45/C55 Upgrade Procedure

Purpose

The purpose of this document is to enable System Administrators to upgrade a CopyCentre from version

2.97.20.000 or later, to version 2.98.50.000.

The upgrade process will take up to half an hour. The CopyCentre will be unavailable during this time.

Please make sure that the CopyCentre is free of faults and jams before starting any part of the upgrade.

Upgrade Requirements

To perform this upgrade, the following will be required:

1. A PC with the Xerox Utilities Tool version 03.00.0012 installed. By default, there will be an icon

called 'Software Upgrade' on the desktop. A copy of the Xerox Utilities is supplied with each

CopyCentre machine (in the left-hand side pocket). Updates are available from www.xerox.com.

2. The DC_02-98-50-000-bot-c.ugd upgrade file, accessible on the same PC.

3. A type A->B USB cable of 1.5m length or less.

Upgrade Process

1. Plug the USB cable from a USB port on the PC into the back of the CopyCentre.

2. Power on the CopyCentre.

3. On the PC, start the Software Upgrade tool and click on 'Select File' button.

4. When the browser window appears, select the file DC_02-98-50-000-bot-c.ugd.

5. Select "Upgrade" to confirm you want to install this software version. This stage may take up to 15

minutes, during which the progress will be indicated both on the CopyCentre screen and on the

utilities tool.

6. Once the upgrade is complete, the Software Upgrade tool will display the Upgrade Status Report,

which should display 'Software Upgrade Successful' against the different modules, with no failures.

Some modules may show 'Software Upgrade Not Required'; this is normal. Close the tool by

clicking on 'OK'.

7. The system will automatically reboot. The message "Restoring Configuration Settings; Please Wait"

will then be displayed. Wait until 'Ready to scan your job' message is displayed

8. If a fax-card is fitted, check that the fax screen appears when the fax tab is selected. If not, power

the machine off/on.

9. Confirm the new software version by pressing the "Machine Status" hard key (the lowest blue button

on the right hand side of the machine user interface screen), then selecting the "Machine Details"

button. Check the System Software Version is now 2.98.50.000.

The CopyCentre is now ready for use.

For further information/troubleshooting please refer to

Other Tips about Xerox multifunction devices are available at the following URL:

http://www.office.xerox.com/support/dctips/dctips.html

Rev.:

Author:

Ed Wilson

Date/Time:

1 Mar 07 09:22

http://www.support.xerox.com/