Xerox 3100MFPX - Phaser B/W Laser Talimatlar Kılavuzu - Sayfa 34

Yazıcı Aksesuarları Xerox 3100MFPX - Phaser B/W Laser için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Xerox 3100MFPX - Phaser B/W Laser 36 sayfaları. Dect phone installation instructions
Ayrıca Xerox 3100MFPX - Phaser B/W Laser için: Kullanıcı Kılavuzu (2 sayfalar), Değerlendirici El Kitabı (12 sayfalar), Kurulum Talimatları (2 sayfalar)

Xerox 3100MFPX - Phaser B/W Laser Talimatlar Kılavuzu
A
PPENDIX

Care and Maintenance

Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may
cause electrostatic charges.

Problems

Refer to the table presented below in case of an operational malfunction:
Problems
The handset display is blank
The handset does not ring
during an incoming call
No radio link between the
handset and base
The network indicator icon
flashes
You obtain a "busy" dial tone for
each dialled number
Remedies
Make sure the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
To increase the life of your batteries, you can perform this operation about every
two months.
If these precautionary measures do not resolve this issue, replacement
batteries are available through your reseller.
As time goes by, you may notice a slight decrease in battery performance. Use
your handset until the battery is fully discharged, and then charge it for at least
12 hours.
Make sure that the telephone is properly connected and that you have a dial
tone.
Make sure your telephone is not set to silent mode (see pargraph Settings).
Make sure your terminal is in FAX-TEL mode.
Make sure the handset is registered by moving closer to the base, if it is
registered correctly, the handset screen should display its own handset number.
Otherwise, register the handset to the base. See "Registering a new handset to
a terminal", page 30.
Make sure no one else is using another handset (if the intrusion mode is
deactived).
35