Xerox PRO785 - WorkCentre Pro 785 B/W Laser Onarım Kılavuzu - Sayfa 2
Yazıcı Aksesuarları Xerox PRO785 - WorkCentre Pro 785 B/W Laser için çevrimiçi göz atın veya pdf Onarım Kılavuzu indirin. Xerox PRO785 - WorkCentre Pro 785 B/W Laser 4 sayfaları. Fusers
Sayfayı Yazdır
• Lift the fuser up and out.
The Pro665 style comes out the same way except that you first need to remove the
front and rear covers so that you can access the front and rear plugs (for the rear plug; you
will actually go to the rear of the machine to disconnect it).
The 7042 works the same way as the Pro665 style (remove the front and rear covers
first) except that it has two rear connectors (CN11 & CN12). You will need to disconnect
both of them where they plug into the Driver Board. The front connector is CN101 which
plugs into the Low Voltage Power Supply (LVPS).
DISASSEMBLY:
1)
Flip the fuser over and remove
the bottom cover, which is as simple as
releasing a pair of clips (one at the front
end and one at the rear end).
3.) Now with the lamp out and in a safe place,
turn the assembly right side up again and
remove the top cover (2 screws and lift it off).
Take notice of the layout of the gears as the 3
idler gears are not captive and will fall off
easily.
2.)
Release the Fuser Lamp Rear Terminal's screw
to disengage the rear terminal. You can slide the Fuser
Heat Lamp out through the front end (the end opposite
the gears).