f.
IPsec: Enable and configure IPsec by following the instructions under "IPsec" in Section 4 of the SAG. Note that IPsec
should be used to secure printing jobs; HTTPS (SSL) should be used to secure scanning jobs. Use the default values for IPsec
parameters whenever possible for secure IPsec setup.
Note: IPsec is disabled when the device is placed in FIPS 140-2 mode. The system administrator should not enable IPsec
when the device is already placed in FIPS 140-2 mode.
V.
The following windows are available to any authenticated and authorized user from the Local User Interface. These windows
provide standard machine services or job management capability:
Pausing an active job being processed by the device – Allows the user to pause an active copy, print, workflow scanning,
scan to email, Internet Fax or Embedded Fax job while it is being processed. Is accessible by selecting the [Stop] machine
hard button while a job is being processed by the device.
VI.
The Web UI provides a set of on-line help pages that provide guidance on most of the Web UI pages. These on-line help pages
can be accessed from the Web UI by selecting the [Help] button on the upper right hand corner of every Web UI page; the on-
line help page corresponding to the Web UI page being viewed will be displayed. There is also a 'Contents' list of all Web UI help
pages to the left of each help page; scrolling through the content list and selecting the desired page will also cause the
applicable on-line help page to be displayed.
VII.
The following pages are available from the Web User Interface with no user login and authentication required:
Index - Provides the user with hyperlink pointers to each Web User Interface screen organized by Web UI tab. Is accessible
by selecting the [Index] button in the upper right hand corner of every Web User Interface page.
Exit from Sleep Mode – Automatically informs the user, when the Network Controller is in 'Sleep Mode' at the time the user
attempts to make a change to current settings on a Web User Interface web page, that the Network Controller needs to be
taken out of 'Sleep Mode' before the requested changes can be made.
VIII.
Customers who required specialized changes to support unique workflows in their environment may request specific changes to
normal behavior. Xerox will supply these SPAR releases to the specific customers requesting the change. Please note that in
general enabling a specialized customer-specific feature will take the system out of the evaluated configuration.
Contact
For additional information or clarification on any of the product information given here, contact Xerox support.
Disclaimer
The information provided in this Xerox Product Response is provided "as is" without warranty of any kind. Xerox Corporation
disclaims all warranties, either express or implied, including the warranties of merchantability and fitness for a particular
purpose. In no event shall Xerox Corporation be liable for any damages whatsoever resulting from user's use or disregard of
the information provided in this Xerox Product Response including direct, indirect, incidental, consequential, loss of business
profits or special damages, even if Xerox Corporation has been advised of the possibility of such damages. Some states do no
allow the exclusion or limitation of liability for consequential damages so the foregoing limitation may not apply.
9
Sayfayı Yazdır