Xerox WorkCentre M118i Hızlı Kurulum Kılavuzu - Sayfa 3

Yazıcı Aksesuarları Xerox WorkCentre M118i için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Xerox WorkCentre M118i 5 sayfaları. Copy/print/fax/email
Ayrıca Xerox WorkCentre M118i için: Kullanıcı Kılavuzu (2 sayfalar), Modül Kılavuzu (2 sayfalar), Hızlı Kurulum Kartı (2 sayfalar), Yazılım Kılavuzu (47 sayfalar), Hızlı Kurulum Kılavuzu (5 sayfalar), Manuel (28 sayfalar), Stand Kurulum Kılavuzu (4 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (1 sayfalar), Kurulum Kılavuzu (1 sayfalar), Başlangıç Kılavuzu (25 sayfalar), Değerlendirici El Kitabı (12 sayfalar), Servis Kılavuzu (12 sayfalar)

Xerox WorkCentre M118i Hızlı Kurulum Kılavuzu
Enabling Scan to E-mail
To enable the Scan to E-mail feature:
1.
On the control panel, press the Log In/Out button.
2.
Press the Select button below the display to select
a.
Use the numeric keypad to enter the Password. The default password is 11111.
b.
Press the Select button to select Confirm.
3.
Select
Print
Settings, and then press the Enter button.
4.
Press the Select button until you see
5.
Use the numeric keypad to enter the Software Option password for Scan to E-mail, and then press the
Enter button. The password can be found on the inside cover of the Scan to E-mail Instructions.

Configuring Scan to E-mail

After Scan to E-mail is enabled, follow these steps to configure Scan to E-mail on your network.
Set the Administrator E-mail Address
1.
At your computer, launch your web browser.
2.
Enter the machine's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click the Properties tab.
4.
Select Machine Details on the left sidebar.
a.
Enter the machine's email address in the Administrator E-mail Address field. If an email address for
the machine has not been created, enter your email address. Once an email address is available for the
M118i machine, repeat Steps 1 through 5 in this procedure to replace your e-mail address with the
machine's email address.
b.
Click the Apply New Settings button at the bottom of the page.
c.
Enter the CentreWare IS administrator's User Name and Password, and then click the OK button.
Note
The default CentreWare IS administrator's User Name is admin and Password is x-admin. These
should be changed after network setup is complete.
d.
At the reboot prompt, click the Reboot button.
5.
Wait one minute for the reboot to complete, and then click the browser Refresh button.
System
Settings.
Software Option
on the display, and then press the Enter button.
Xerox WorkCentre M118i
3
Enabling Scan to E-mail