Xerox WorkCentre Pro 123 Hızlı Ağ Kurulumu Kılavuzu - Sayfa 6

Yazıcı Aksesuarları Xerox WorkCentre Pro 123 için çevrimiçi göz atın veya pdf Hızlı Ağ Kurulumu Kılavuzu indirin. Xerox WorkCentre Pro 123 7 sayfaları. Stand installation guide
Ayrıca Xerox WorkCentre Pro 123 için: Kurulum Kılavuzu (2 sayfalar), Değerlendirici El Kitabı (12 sayfalar), Broşür ve Teknik Özellikler (6 sayfalar), Broşür ve Teknik Özellikler (6 sayfalar), Kurulum Kılavuzu (2 sayfalar), Ağ Kılavuzu (50 sayfalar), Tarama Kılavuzu (28 sayfalar), Hızlı Kurulum Kartı (2 sayfalar), Çıkış Kiti Kurulum Kılavuzu (4 sayfalar), Donanım Kurulum Kılavuzu (4 sayfalar), İki Tepsili Modül Kurulum Kılavuzu (4 sayfalar), İnvertör Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Donanım Kurulum Kılavuzu (2 sayfalar), Stand Kurulum Kılavuzu (2 sayfalar)

Procedures for manual setup of network using Static IP Address:

Step 1

: Power on the M123/M128 device.

Step 2:

Select on "Login/Logout". Enter the UserID (11111). Select "System Settings"

"System Settings"

Step 3

: Select "IP address" and Press "Change Settings". Enter the IP address of the

machine. If there is an incorrect IP address in the field hit the Clear button once to delete the

incorrect IP address.

For Example:

To enter in our example IP address of 10.224.40.57, type 10 then press the "Next" key. Type 222

(There is no need to hit the" Next" key now because the octet field is full. In this case, the cursor

selection automatically moves to the next octet field of the IP address). Type 40 then press the

"Next" key, and then type 57. Press the Exit key when done.

Step 4

: Enter in the Default Gateway, Subnet Mask.

OTE

DNS setting must be entered through the Internet Services

Step 5

: From a workstation, open a web browser (such as Internet Explorer). Type in the URL,

http://xxx.xxx.xxx.xxx

you should be presented with the M123/128 device's CentreWare Internet Services web page

(see Figure 1).

Step 6: Load the Print Drivers on the workstations that will be accessing the M123/M128 device.

For more detailed instructions, see the System Administrator Guide.

OTE:

The Default Gateway, Subnet Mask and DNS address settings can be entered via

CentreWare Internet Services if the device is on the same subnet as the workstation. To access

them via CentreWare Internet Services type in the M123/128 device's IP address in the Url. Click

on the Properties tab, then click the Protocols Settings folder, Click on the TCP/IP. See

example on the next page.

QNS

"Network Settings"

(the xxx's represent the M20 device's IP address). If connected properly,

Page 6 of 7

Protocol Settings.

701P42078