Xerox WorkCentre Pro 645 Onarım Kılavuzu - Sayfa 2

Yazıcı Aksesuarları Xerox WorkCentre Pro 645 için çevrimiçi göz atın veya pdf Onarım Kılavuzu indirin. Xerox WorkCentre Pro 645 4 sayfaları. Copying documents
Ayrıca Xerox WorkCentre Pro 645 için: Kurulum Kılavuzu (1 sayfalar), Kullanıcı Kılavuzu (14 sayfalar), Tamamlayıcı Kılavuz (2 sayfalar), İşlev Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (9 sayfalar)

• Lift the fuser up and out.

The Pro665 style comes out the same way except that you first need to remove the

front and rear covers so that you can access the front and rear plugs (for the rear plug; you

will actually go to the rear of the machine to disconnect it).

The 7042 works the same way as the Pro665 style (remove the front and rear covers

first) except that it has two rear connectors (CN11 & CN12). You will need to disconnect

both of them where they plug into the Driver Board. The front connector is CN101 which

plugs into the Low Voltage Power Supply (LVPS).

DISASSEMBLY:

Flip the fuser over and remove

the bottom cover, which is as simple as

releasing a pair of clips (one at the front

end and one at the rear end).

3.) Now with the lamp out and in a safe place,

turn the assembly right side up again and

remove the top cover (2 screws and lift it off).

Take notice of the layout of the gears as the 3

idler gears are not captive and will fall off

easily.

2.)

Release the Fuser Lamp Rear Terminal's screw

to disengage the rear terminal. You can slide the Fuser

Heat Lamp out through the front end (the end opposite

the gears).