Xerox 850N - Phaser Color Solid Ink Printer Yayın Notu - Sayfa 20

Yazılım Xerox 850N - Phaser Color Solid Ink Printer için çevrimiçi göz atın veya pdf Yayın Notu indirin. Xerox 850N - Phaser Color Solid Ink Printer 33 sayfaları. Installation guide for accxes 10.2
Ayrıca Xerox 850N - Phaser Color Solid Ink Printer için: Teknik Özellikler (2 sayfalar), Operatör El Kitabı (16 sayfalar), Tamamlayıcı Kılavuz (1 sayfalar), Tamamlayıcı Kılavuz (11 sayfalar), Kurulum Kılavuzu (1 sayfalar), Temizlik Talimatları Kılavuzu (9 sayfalar), Yükseltme Kılavuzu (8 sayfalar), Tamamlayıcı Kılavuz (26 sayfalar), Yayın Notu (11 sayfalar), Yayın Notu (11 sayfalar), Kurulum Talimatları (2 sayfalar)

8.2 Xerox 6030/6050 Wide Format Solution

Long plot limits are dependent on the amount of memory in the 6030/6050. Limits are as follows:

Amount of Memory

Installed

256 MB

512 MB

1 GB

If the maximum plot length in AccXES (in WebPMT: PRINTER DEFAULTS>PROCESSING

DEFAULTS>MEDIA>MAXIMUM PLOT LENGTH) is set greater than the maximum length of the

6030/6050 the image will be truncated.

Copy documents should be limited to the maximum length printed by the 6030/6050 printer. If

longer documents are used the printer may not print them correctly and may hang. Canceling a

long copy job may require a very long time to complete or may hang the system requiring it to be

rebooted.

When the 6030/6050 printer runs out of toner the error message presented in WebPMT is simply

"printer needs attention". The user needs to refer to the printer user interface to determine the

problem resolution required.

When the "Clear Last Image" feature is selected on the Xerox Wide Format Scan System, it may

take a few minutes for a Photo or Color mode scanned document to clear out. After scanning a

document, this feature is accessed by selecting the "C" key on the scanner. It will bring up the

"CLEAR SCANNED IMAGE" screen. Use the "Next" button to select "CLEAR LAST IMAGE", and

then press "ENTER".

Scan a document. Press the Transform key. Select "Recall Last Job". If the Invert feature

(changes dark to light and vice versa) is selected before printing the recalled document, the

document will not be inverted. It will need to be rescanned to get the inverted image.

Page 20

Long Plot Limit

3,000 mm

7,500 mm

15,000 mm