3.
In the Add Port dialog box, select Other.
4.
From the list of available printer port monitors, select the Xerox TCP/IP Port, and then click the
OK button.
5.
At this point, you enter the Xerox TCP/IP Printer Port Wizard. The wizard guides you step-by-
step through the following procedures:
a.
Choosing a name for the new port.
b.
Identifying a printer by its DNS Name or IP Address.
c.
(Alternatively) Identifying a printer using the automatic Printer Discovery feature. Click
Next to proceed with the port installation.
6.
The wizard verifies the port name and printer address, and automatically configures the remaining
port settings for you. Any errors detected in printer identification displays a dialog box requesting
Additional Information.
In the Add Xerox TCP/IP Port window:
a.
Under Enter a Port Name, enter a unique name for the port being added.
b.
Under Enter a printer name or IP address, enter the printer's host name or IP Address.
c.
Click Next.
Note
To locate Xerox printers on your local area network, select Auto Printer Discovery, and
then click Refresh. The Xerox TCP/IP Port Monitor searches the network for Xerox printers
and displays them in a list. Select your desired printer from the list and click OK.
7.
After all the port settings have been configured and verified, a Completing dialog box appears
summarizing all of the settings. You have the opportunity to change any of the settings by clicking
the Back key. Otherwise, click the Finish key to complete the port setup.
8.
Click OK to exit from Printer Properties. This completes the installation of the Xerox TCP/IP
Port.
Windows 2000/XP troubleshooting (TCP/IP)
Note
For Windows XP, switch to Classic Look using the Taskbar and Start Menu Properties
dialog box. Otherwise, Windows XP procedures do not match the steps below.
This troubleshooting section assumes you have completed the following tasks:
You have loaded a Phaser printer PCL or PostScript print driver.
You have printed and retained a current copy of the Configuration Pages. For information on
printing Configuration Pages, refer to the Front Panel section of the Features Guide on the
Interactive Documentation CD-ROM.
1.
Verify these items in the TCP/IP area of the Configuration Pages:
IP Address Source is set to DHCP, Front Panel, BOOTP, or Auto IP (depending on your
network configuration).
Phaser® 7300 Color Printer
Windows 2000/XP Network
27
Sayfayı Yazdır