Xerox WORKCENTRE C2424 Kullanıcı Kılavuzu - Sayfa 2

Yazılım Xerox WORKCENTRE C2424 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Xerox WORKCENTRE C2424 43 sayfaları. Copier-printer
Ayrıca Xerox WORKCENTRE C2424 için: Hızlı Referans Kılavuzu (14 sayfalar), Broşür (8 sayfalar), Tamamlayıcı Kılavuz (7 sayfalar), Teknik Özellikler (6 sayfalar), Başlangıç Kılavuzu (26 sayfalar), Kullanıcı Kılavuzu (21 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Bakım Kılavuzu (20 sayfalar), Kullanıcı Kılavuzu (19 sayfalar), Talimatlar Kılavuzu (16 sayfalar), Manuel (12 sayfalar), Talimatlar Kılavuzu (6 sayfalar), Kurulum Kılavuzu (4 sayfalar), Kurulum Kılavuzu (2 sayfalar), Besleme Silindiri Kitinin Değiştirilmesi (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Gönüllü Ürün Erişilebilirlik Şablonu (10 sayfalar), Rekabetçi Karşılaştırma (3 sayfalar), Hızlı Referans Kılavuzu (14 sayfalar), Servis Kılavuzu (11 sayfalar), Hızlı Referans Kılavuzu (13 sayfalar)

Connections and Internet Protocol (TCP/IP)

This section includes:

■

"Overview of Network Setup and Configuration" on page 6-2

"Choosing a Connection Method" on page 6-3

■

"Connecting via Ethernet (Recommended)" on page 6-3

■

"Connecting via USB" on page 6-4

"Configuring the Network Address" on page 6-5

■

"infoSMART Knowledge Base Documents (English only)" on page 6-8

This section includes connecting the multifunction system to the network via Ethernet or USB,

then configuring the system's TCP/IP or AppleTalk/EtherTalk address for the particular

network and operating system.

Overview of Network Setup and Configuration

Network connection and configuration steps are performed in the following order.

Turn the system and the computer On.

Connect the system to the network using the recommended hardware and cables.

Configure the system's network address, which is required to identify the system on the

network. Run the Installer on the WorkCentre C2424 Software CD-ROM to automatically

set the system's IP address, if the system is connected to an established TCP/IP network.

If you do not want to run the Installer to automatically set the IP address, you can do one

of the following:

■

For Windows operating systems, use TCP/IP to manually set the multifunction

system's IP address.

■

For Macintosh, use TCP/IP or AppleTalk/EtherTalk to set the system's network

address.

Install the driver software on the computer from the WorkCentre C2424 Software CD-

ROM. For information on driver installation, see the section in this chapter for the specific

operating system you are using.

Note

If the WorkCentre C2424 Software CD-ROM is not available, you can download the

latest driver from www.xerox.com/office/drivers.

Connections and Internet Protocol (TCP/IP)

WorkCentre® C2424 Copier-Printer

6-2