Xerox Nuvera 100 Kullanım Kılavuzu - Sayfa 11

Yazdırma Sunucusu Xerox Nuvera 100 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Xerox Nuvera 100 34 sayfaları. Production system
Ayrıca Xerox Nuvera 100 için: Şartname Sayfası (2 sayfalar), Özellikler Kılavuz (34 sayfalar), Planlama Kılavuzu (22 sayfalar), Kullanıcı Kılavuzu (40 sayfalar), Referans Kılavuzu (2 sayfalar), Planlama Kılavuzu (20 sayfalar), Referans Kılavuzu (42 sayfalar), Hızlı Referans (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Tamamlayıcı Kılavuz (48 sayfalar), Planlama Kılavuzu (38 sayfalar), Planlama Kılavuzu (16 sayfalar), Referans Kılavuzu (2 sayfalar), Teknik Özellikler (2 sayfalar), İpuçları ve Tavsiyeler Kılavuzu (18 sayfalar), İpuçları ve Tavsiyeler Kılavuzu (18 sayfalar), Başlangıç Kılavuzu (26 sayfalar), Başlangıç Kılavuzu (30 sayfalar)

Contents

NPS/IPS Extension Operations Guide

Introduction

This document provides all the information you need to install, set

up, and operate the NPS/IPS Extension option on the DocuPrint

100/115/135/155/180 EPS. It also describes the procedure for

switching between operating modes and provides troubleshooting

information. This document is intended for the site system

administrator who is responsible for installing and setting up the

NPS/IPS Extension option, and for the Operator who is

responsible for the day-to-day operations.

Before using this documentation, become familiar with its contents

and conventions.

This guide contains the following:

•

Chapter 1, "Product overview," provides detailed explanations

of the NPS/IPS Extension option.

•

Chapter 2, "Installation planning," gives you the information

that you need to prepare for installation of the NPS/IPS

Extension software.

•

Chapter 3, "Changing print modes," provides procedures for

switching between EPS, and NPS/IPS operating systems.

•

Chapter 4, "Problem solving," provides troubleshooting

information about switching between print modes.

•

An index is provided at the end of this document.

This guide uses the following conventions:

•

Initial capital and angle brackets: Within procedures, the

names of keys are shown with an initial capital and within

angle brackets (for example, press <Enter>).

•

Angle brackets: Variable information, or the position of a

specified argument in the command syntax, appears in angle