Xerox Phaser 6100DN Kullanıcı Kılavuzu - Sayfa 10

Yazdırma Sunucusu Xerox Phaser 6100DN için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Xerox Phaser 6100DN 32 sayfaları. Disk overwrite installation and usage
Ayrıca Xerox Phaser 6100DN için: Kurulum Kılavuzu (34 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı Kılavuzu (32 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Kullanıcı Kılavuzu (28 sayfalar), Kurulum Kılavuzu (2 sayfalar), Güvenlik Kılavuzu (38 sayfalar), Kurulum Kılavuzu (2 sayfalar), Yayın Notu (2 sayfalar), Başlangıç Kılavuzu (37 sayfalar), Manuel (34 sayfalar), Manuel (34 sayfalar), Başlangıç Kılavuzu (34 sayfalar), Kurulum ve Kullanım Kılavuzu (8 sayfalar)

your CD are listed:

•

600 dpi CD: E13B, E13B9, and CMC72510 are listed.

•

300 dpi CD: E13B and CMC72510

NOTE: The DocuPrint 75 EPS does not support the CMC7 fonts.

For these systems, select only E13B and E13B9 (if available).

e. Highlight the required fonts, and click Install. A Question

window tells you that loading the fonts from CD could take

over 30 minutes. Click OK.

Watch the lower-left corner of the window. The "Installing

Fonts...Done" message is displayed briefly.

Close the Install Postscript Soft Fonts window by clicking

Close.

g. If you do not intend to install any more fonts, click the

green triangle icon to eject the CD.

NOTE: The PostScript fonts are available only after the system is

restarted.

6. If PCL MICR fonts are needed, follow these steps:

a. With the MICR Fonts CD still in the CD drive, select PCL

Cartridge from the Font Type pull-down menu.

b. Click Load.... The Install PCL Cartridge Fonts window

opens.

c. In the Look In... pull-down menu, select DOS CD-RW 0.

d. Click List Fonts. In the Files section, the following PCL

fonts are listed:

•

E13B-P (300 dpi font)

•

E13B (600 dpi font)

•

CMC72510

•

68W

e. Highlight the required fonts, and click Install. The "Installing

Fonts...Done" message is displayed briefly in the lower-left

corner of the Install PCL Cartridge Fonts window.

If you do not intend to install the LCDS fonts, click the

green triangle icon to eject the CD.

g. Click Close on the Import PCL Cartridge Fonts window,

then OK.

7. Restart the system to make all fonts available.

MICR User Guide