Direct Supply Panacea TILT CHAIR Kullanıcı El Kitabı - Sayfa 6

Tekerlekli Sandalye Direct Supply Panacea TILT CHAIR için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Direct Supply Panacea TILT CHAIR 16 sayfaları. Weight capacity standard: 350 lbs.; bariatric: 450 lbs.

Sayfayı Yazdır

Tilt Operation

The seat tilt angle can be adjusted from 0 to -55

degrees. In order to tilt the chair:

• Locate the tilt mechanism handle. The handle is

located at the rear of the chair, on the right push bar,

marked with a "TILT" label (Figure 3).

• Squeeze the handle and tilt the chair back or forward

to the desired angle.

• When the desired angle has been achieved, release

the handle to lock the position into place.

• Ensure the legrest is extended, and to the desired

comfort level.

• WARNING: The caregiver should use and familiarize

himself or herself with the handle mechanism prior to

operating the chair.

• WARNING: The caregiver should assess the user's

abilities, weight and physical condition to determine the

sufficient degree of tilt. An improper tilt degree could result in a tipping of the chair and/or the user

sliding or falling off the chair.

• WARNING: The mechanical lock must be operational before using the chair. Do not operate the

tilt mechanism if the mechanical lock is not operational.

• WARNING: Ensure the user's arms and hands are inside the chair frame and clear of all pinch

points before adjusting the tilt angle.

Headrest Adjustment

The height of the headrest is adjustable. To adjust the headrest:

• Unbuckle the fastening strap and raise or lower the headrest.

• When the desired position is achieved, reattach the fastening strap with the buckle at the rear of the chair.

Lateral Supports

The lateral supports are detachable and interchangeable.

They can be used in various combinations, individually or

collectively, to provide upper-body or lateral support.

To adjust the lateral supports:

• Unscrew the grip knobs counterclockwise slightly until

the gap is large enough to detach the support (Figure 4).

The grip knobs do not need to be completely removed

to detach the lateral supports.

• Reattach the lateral supports into the desired position.

• Turn the grip knobs clockwise until tightly fastened.

There are two grip knobs per lateral support.

NOTE: The lateral side supports can be attached in two

width orientations to accommodate different size users

(Figures 5 and 6). To adjust the width between the right and left lateral supports, remove the left

lateral support and install it on the right side, and vice-versa.

Operating Instructions

Figure 3

Figure 4