Alderon Industries Vizzyalarm VZW-02 Kullanım, Bakım ve Kurulum Kılavuzu - Sayfa 2
Güvenlik Sistemi Alderon Industries Vizzyalarm VZW-02 için çevrimiçi göz atın veya pdf Kullanım, Bakım ve Kurulum Kılavuzu indirin. Alderon Industries Vizzyalarm VZW-02 6 sayfaları.
Sayfayı Yazdır
Vizzyalarm™ 1-Zone WiFi Alarm Panel - Installation Instructions
Installation of the Alarm Panel
1. To install/replace the batteries for the backup power feature, remove the enclosure cover (Fig. 1) and install one (1) AA
battery into each of the battery receptacles of the alarm panel (3 total / Fig. 2). Make sure to have the proper orientation
of the positive (+) and negative (-) terminals of each battery to ensure a secure connection. After installing the batteries,
the green power LED should illuminate (slow flash). To perform a quick test, press and hold the test/silence pushbutton
(Fig. 2 and Fig. 3) to activate the alarm. If properly installed, all of the LEDs should illuminate (quick flash) and then after
approximately 5-6 seconds, the buzzer should annunciate (quick pulse). Immediately release the test/silence pushbutton
after the buzzer annunciates a quick pulse tone to end the test. Leave the enclosure cover off until both step 3 and
step 4 are completed for sensor and auxiliary contact wiring.
CAUTION: Holding the test/silence pushbutton for longer than 5-6 seconds along with the buzzer quick pulse tone will
change the low battery alarm enable or disable setting (approximately 9-10 seconds; total elapsed time). See complete user
guide for settings information and page 4 to test auxiliary contacts separately.
WARNING: Do not connect AC power from a standard wall outlet or receptacle to the alarm panel until all steps of the
installation are complete and the system is ready for testing.
(Fig. 1)
2. Determine the mounting location for the alarm panel and leave the enclosure cover off. Make sure power outlet (120VAC,
50/60 Hz) is within 5-feet of the alarm panel (Fig. 4). The power outlet should be on a separate circuit breaker from any
other device and not on a switched receptacle to maintain system integrity. Mount the alarm panel using two (2) #6
self-tapping screws (not included / Fig. 5). Use two (2) #8 plastic anchors (not included / Fig. 6) if mounting the alarm
panel to sheet rock.
(Fig. 4)
Page 2 | Installation Instructions
Alderon Industries, LLC - Leading Edge Control Products | 218.483.3034 | [email protected] | [email protected] | alderonind.com
(Fig. 2)
2D
2A
2E
2F
2G
+
5 ft. Max
2A
2B
(without batteries)
+
2A = Battery Receptacles
2C
2B = (3) AA Batteries
2C = Test/Silence Pushbutton
2D = Power LED
(green)
2E = Alarm LED
(red)
2F = Vizzy/WiFi LED
2G = Alarm Buzzer
(Fig. 5)
(Fig. 3)
+
-
(blue)
(Fig. 6)