Yamaha DC9190A Kullanıcı El Kitabı - Sayfa 5

Müzik Enstrümanı Yamaha DC9190A için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha DC9190A 7 sayfaları. Deagan chimes series

Make sure the chimes are assembled or disassembled by at least two persons.

Connect the pedal assembly to the left and

right base sections.

Position the pedal assembly and left/right base

sections as shown in the illustration below.

* The following procedure is carried out to en-

sure that the performer faces forward when

playing the instrument.

Fully loosen screws A, and then slide the pedal

assembly pipe all the way into the hole on the

base section. Tighten screws A to secure.

After connecting the assembly pipe to the base

sections, lock the casters (left and right).

Insert the side columns into the holes on

the left and right base sections.

Fully loosen screws B and insert the end of the

side column pipe with the small hole on its side,

all the way into the left and right side base sec-

tions.

* Both left and right side columns are the same.

* To make attachment of the damper and hanger

sections easier, do not tighten screws B yet.

Set the damper.

Fully loosen screws C and slide the damper onto

the side columns from above so that the damper

rod is positioned on the right. Slide the damper

down the columns until it comes to rest on the

damper rests.

* To make attachment of the hanger section

easier, do not tighten screws C yet.

Set the hanger.

Slide the hanger onto the side columns from

above. Slide it all the way onto the columns.

Tighten screws B and C.

Firmly tighten screws B and C on both right and

left sides and secure.

Set the damper pedal.

Pull the damper pedal out to the front, and then

hook the hook on the end of the pull rod onto the

damper rod. At this time, pull down on the pull

rod knob to hook onto the damper rod, then re-

lease the pull rod knob.

* Do not press down on the damper pedal. Do-

ing so engages the damper and the sound

columns cannot be hung.