Yamaha TP-5032H Kullanıcı El Kitabı - Sayfa 5
Müzik Enstrümanı Yamaha TP-5032H için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha TP-5032H 12 sayfaları. Pedal timpani
Ayrıca Yamaha TP-5032H için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (12 sayfalar)
Sayfayı Yazdır
5
Using the supplied timpani key, tighten the tun-
ing bolts by 1/4 of a turn (90°) in the order
shown below. It is very important to always
turn all tuning bolts by the same amount.
Timpani key
26", 29", 32"
6
Take your foot off the pedal.
G Heel still moves up
¡ Repeat steps
G Heel stays down
¡ Go to step
7
.
7
Put your foot on the pedal and fully depress it in
either direction (toe and heel).
G Heel feels heavier than toe
¡ Go to step
8
.
G Toe and heel feel equal
¡ Go to step
11
.
G Heel feels lighter than toe
¡ Head is tightened too much. Loosen the
head. Keeping the heel of the pedal de-
pressed, loosen the first tuning bolt by 1/
2 turn and then retighten it by 1/4 of a
turn. Perform this operation for all other
tuning bolts in the order shown in step
If necessary, repeat this procedure, until
proper tension is obtained.
8
Fully depress the heel of the pedal as shown in
Fig. C.
As the head will stretch over time, readjustment should be performed periodi-
Note
cally (starting with step
20", 23"
4
6
through
.
7
)
Before Using The Pedal Timpani
9
Tighten each tuning bolt by 1/8 of a turn (45°) in
the order shown in step
10
G Toe and heel feel equal
¡ Go to step
G Heel still feels heavier than toe
¡ Repeat steps
G Heel feels lighter than toe
¡ Head is tightened too much. Loosen the
head as described in step
11
Move the pedal into an intermediate position, as
shown in Fig. D, and remove your foot from the
pedal. Confirm that the pedal stays in this posi-
tion and does not move.
If the pedal stops in this position, adjust-
ment is complete. Return the pedal to the
position shown in Fig. C.
G If the toe of the pedal moves downward
¡ Repeat steps
G If the heel of the pedal moves downward
¡ Head is tightened too much. Loosen the
head as described in step
12
Strike the head lightly with the supplied mallet
etc. The standard striking point is shown below.
Striking point
Pedal
5
.
For note comparison a piano is most suitable.
When the toe of the pedal is depressed, a higher
pitch is obtained.
For details on precise tuning refer to "Adjusting
The Sound Of Your Timpani" on the following
page.
5
.
11
8
10
through
7
.
8
10
through
.
7
.
The standard striking
point lies at distance
B from the kettle
edge, which
corresponds to 1/4 to
1/3 of distance A
(distance between
kettle edge and
center of head).
5