Yamaha YM-460 Kullanıcı El Kitabı - Sayfa 9

Müzik Enstrümanı Yamaha YM-460 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha YM-460 19 sayfaları. Concert marimbas
Ayrıca Yamaha YM-460 için: Kullanıcı El Kitabı (20 sayfalar)

Sayfayı Yazdır

Insert the rails (2) and (3) into the frame ends of the legs.

2-1. First, insert the rail (2). Make sure that the end of the rail with the tone bar posts spaced further apart

is positioned on the bass side.

A mark "B" is printed on the large end face of the rail (2) and the groove section of the frame end of

the large end leg.

* Do not insert one side of the rail all the way down first, but push both sides into grooves alternately little by

little until both sides are inserted fully and stop.

Tone bar height can be adjusted at this point. (Refer to n on page 32.)

Rail (4): With YAMAHA logo. Logo side facing the audience.

High sound

side

2-2. After confirming that legs on the left and right sides are vertical, use the

screw to connect the end of the stay to the hole for attaching the stay in

the long frame (2) and firmly tighten the screw.

* The YM-410 and 410F have two (2) holes. When leg height is set low, use the

hole closer to the center of the instrument, and when the leg height is high, use

the outer hole and tighten the screw firmly.

2-3. Next, in the same way, insert the rail (3) securely.

A mark "C" is printed on the large end face of the

rail (3) and the groove section of the frame end of

the large end leg.

2-4. Engage the short rail clamp located at the center of

the rail (3) with the rail (2).

(3): Both sides have clamps attached. The side with the shorter clamp should face the player.

(2): Hole for attaching the stay. The side with the threaded hole should face the audience.

Audience side

YM-460/460F/410/410F/46/41

(1)

ASSEMBLY

Tone bar posts

Player side

Frame end

Low sound

side

Rail (2)

Slant shaft