Yamaha YV-3710 Kullanıcı El Kitabı - Sayfa 20

Müzik Enstrümanı Yamaha YV-3710 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha YV-3710 28 sayfaları. Concert vibraphones
Ayrıca Yamaha YV-3710 için: Kullanıcı El Kitabı (28 sayfalar), Kullanıcı El Kitabı (29 sayfalar), Kullanıcı El Kitabı (34 sayfalar)

Sayfayı Yazdır

ASSEMBLY: YV-3910/3710/3700

10-4 Tone Bar Height Adjustment

This adjustment should always be performed by at least 2 persons.

To adjust the height of the tone bars, first remove the synchro belt, driver, controller,

tone bars, and resonators in the reverse order of steps

loosen the center rod fixing bolts.

Loosen the slide leg fixing bolts on the high and low sound sides, while supporting the

frame ends by hand.

Lift the frame ends to the desired height and then securely tighten each fixing bolt,

aligning it with the corresponding notch of the slide leg. Bolt and notch are aligned

when the next higher notch is flush with the upper leg flange.

After assembly, confirm that each bolt and screw is tightened securely.

Align notch with

upper flange.

When a slide leg fixing bolt is tightened in between two notches,

there is a danger of the slide leg slipping. Always make sure

that the slide legs are held securely.

Slide Leg

Do not touch the notched

part during height adjust-

ment to avoid injury.

* The fourth notch from top

corresponds to the standard

height setting.

, and