Yamaha 501 Kullanıcı El Kitabı - Sayfa 15

Elektronik Klavye Yamaha 501 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha 501 24 sayfaları. Internet connection guide (version 1.10)
Ayrıca Yamaha 501 için: Kullanıcı Kılavuzu (20 sayfalar), Kurulum Kılavuzu (32 sayfalar), Bağlantı Kılavuzu (22 sayfalar)

Sayfayı Yazdır

Notes

You can program as many as 40 tracks at one time.

If you choose to perform programming with the DISC 1 tray

empty, be sure to press a DISC SKIP button before starting

programming.

You can program a whole disc by pressing "0", instead of

one track. At that time, "AL" flashes in the display.

If you will program tracks from more than one disc, before

you press the PROG button, check the total recorded time of

each disc on the disc tray by pressing the DISC SKIP button

in turn. Without this operation, the total time of the

programmed tracks will not be displayed during

programming.

To stop program play

Press the STOP button. The first programmed track number

will be displayed.

To resume play, press the PLAY button. Play will begin from

the beginning of the program.

To cancel a programmed sequence

There are several methods, as described below.

Press the STOP button while the unit is stopped.

Open the disc tray.

Switch off the power.

CDC-501 only

Press the CLEAR button while the unit is stopped.

The total time of the programmed tracks will not be

displayed, if a track number higher than 20 is programmed.

If, during programming, the TIME display mode-select button

is pressed, the program number display can be changed to

display the total time of the programmed tracks or no

information. To return to the previous display, press the

TIME display mode-select button once again.

The SKIP (

and

playing, but only within the range of the programmed tracks.

The SEARCH (

and

playing to search through all tracks, including

unprogrammed tracks.

To check programmed data

1. If during program play, press the STOP button.

2. Press the PROG button.

3. Each time the SKIP

numbers and sequential order of the programmed tracks

can be checked one after another. The display of the track

number can be returned (sequentially in reverse order) by

pressing the SKIP

To correct programmed data

1. Follow the procedure described in "To check programmed

data".

2. Display the track number to be corrected by pressing the

SKIP button.

3. Press a numeric button to select a track to replace the one

displayed. The previously programmed track will be

cleared from the memory and the new one will be

programmed.

4. After the correction has been completed, press the PROG

button or PLAY button once again.

) buttons can be used during

button is pressed, the track

button.