Yamaha Electone HS-8 Kullanıcı El Kitabı - Sayfa 12

Elektronik Klavye Yamaha Electone HS-8 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha Electone HS-8 20 sayfaları. Serie hs monitor da studio alimentato e subwoofer alimentato
Ayrıca Yamaha Electone HS-8 için: Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (2 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (21 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Servis Kılavuzu (43 sayfalar), (İngilizce) Kullanım Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Yamaha Electone HS-8 Kullanıcı El Kitabı

 Recommended cables

Cables for connecting the audio source (audio

interface, etc.) to the HS8S

 For connection to a balanced phone jack input.

 For connection to a balanced XLR input.

 For connection to an unbalanced phone jack input.

Cables for connection between the HS8S and

HS8/HS7/HS5

HS8

HS7

HS5

NOTE Refer to "Connection and Cable Types" on page 14 for more

connector details. The configurations of the balanced and

unbalanced phone jack connectors are different.

 Settings for Speakers Plus Subwoofer

Once the subwoofer connections have been made and

the layout is finalized, you can begin making the

following settings.

Turn the level/volume controls on all

source equipment (audio interface, etc.) all

the way down.

HS8/HS7/HS5/HS8S Owner's Manual

HS8S

HS8

HS7

HS5

Set the HS8/HS7/HS5 LEVEL control to the

12-o'clock position, and set both ROOM

CONTROL and HIGH TRIM switches to 0

dB.

Set the HS8S LEVEL control to 0, the HIGH

CUT and LOW CUT controls to their 12-

o'clock positions, and set the LOW CUT

switch to OFF.

Turn power on in the following order: audio

source devices, then subwoofer, and finally

the full-range speakers.

NOTE Turn power off in the following order: full-range

speakers, then subwoofer, and finally audio source

devices.

Play some source material and gradually

raise the level/volume controls on the

source equipment.

NOTE Be careful not to suddenly apply an excessively loud

signal to the system. Excessive level can damage the

speakers.

Set the HS8S LEVEL control to between 10

and 12 o'clock, and turn the LOW CUT

switch ON.

Set the listening level to a level at which

you can listen comfortably without fatigue

for an extended period of time.

NOTE If necessary, adjust the ROOM CONTROL and HIGH TRIM

switches for the most natural response (refer to page 7).

NOTE If necessary, adjust the LOW CUT and HIGH CUT controls

and the PHASE switch for the most natural response (refer to

page 8).