Yamaha HTR-2866 Kurulum Kılavuzu - Sayfa 8

Alıcı Yamaha HTR-2866 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Yamaha HTR-2866 19 sayfaları.
Ayrıca Yamaha HTR-2866 için: Kolay Kurulum Kılavuzu (8 sayfalar)

Sayfayı Yazdır

• If any error message (such as E-1) or warning message (such

as W-2) appears, see "Error messages" or "Warning

messages" in "Owner's Manual".

• If the warning message "W-1:Out of Phase" appears, see "If

"W-1:Out of Phase" appears".

Use the cursor keys (e/r) to select

"SAVE" (Save) and press ENTER.

A u t o S e t u p

M e a s u r e m e n t

F i n i s h e d

S t a r t

Result

E x i t

S A V E

3 / 2 / 0.1 ch

3.0 / 10.5 m

3.0 / +10.0 dB

>Save

Cancel

Disconnect the YPAO microphone from the

unit.

This completes optimization of the speaker settings.

• The YPAO microphone is sensitive to heat, so should not be

placed anywhere where it could be exposed to direct sunlight or

high temperatures (such as on top of AV equipment).

If "W-1:Out of Phase" appears

Follow the procedure below to check the speaker

connections.

A u t o S e t u p

S t a r t

E x i t

a Check for the blinking of the front display's indicator to

identify the problem speaker.

VOL

W-1:PHASE

b Check the cable connections (+/-) of the problem

speaker.

If the speaker is connected correctly:

Depending on the type of speakers or room

environment, this message may appear even if the

speakers are connected correctly.

Proceed to step 3.

If the speaker is connected incorrectly:

Turn off the unit, reconnect the speaker cable, and then

try YPAO measurement again.

M e a s u r e m e n t

F i n i s h e d

Result

3 / 2 / 0.1 ch

3.0 / 10.5 m

3.0 / +10.0 dB

OK:ENTER

Warning

W 1:Out of Phase

message

Problem speaker (blinks)

VOL