Yamaha HTR-5230RDS Kullanıcı El Kitabı - Sayfa 15
Alıcı Yamaha HTR-5230RDS için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha HTR-5230RDS 50 sayfaları. Natural sound av receiver
Connecting a Video Component
DVD/LD player
ANALOG
VIDEO
AUDIO OUT
OUT
L
R
V
L
R
AUDIO
OUT
Audio signal terminals
Be sure to connect the right channel (R), left channel (L),
input (IN) and output (OUT) properly.
Video signal terminals
Be sure to connect the input (IN) and output (OUT)
properly.
Digital audio signal terminals
If your DVD/LD player, TV/digital TV or satellite
tuner, etc. has coaxial or optical digital signal output
terminals, they can be connected to this unit's COAXIAL
and/or OPTICAL digital signal input terminals. To make a
connection between the optical digital signal terminals,
remove the cover from each terminal, and then connect
them by using a commercially available optical fiber cable
that conforms to EIA standards. Other cables might not
function correctly.
When making connections between the digital signal
terminals, you should connect the components to the same-
named analog audio signal terminals of this unit, because a
digital signal cannot be recorded by a tape deck, MD
recorder or VCR connected to this unit.
COAXIAL
OPTICAL
DIGITAL OUT
DIGITAL OUT
C
O
(Europe model)
L
R
V
AUDIO
VIDEO
IN
OUT
VCR
TV/digital TV, satellite tuner, cable TV
OPTICAL
DIGITAL OUT
O
V
L
R
No connection
SCART-plug
V
VIDEO
IN
TV monitor
TV monitor with a 21-pin connector
Make a connection as shown above with a commercially
available SCART-plug connector cable.
Notes
• Be sure to attach the covers when the OPTICAL terminals are not
being used in order to protect them from dust.
• If your LD player has a Dolby Digital RF signal output terminal,
be sure to use the RF demodulator (separately purchased).
• No sound will be heard when connecting your LD player's Dolby
Digital RF signal output terminal directly to this unit's COAXIAL
DVD/LD digital signal input terminal.
y
• The input signal from the DVD/LD input terminals is selected in
the following order of priority with the input mode set to AUTO:
COAXIAL terminal
Refer to page 21 for details.
• All digital signal input terminals are applicable to sampling
frequencies of 32 kHz, 44.1 kHz and 48 kHz.
CONNECTIONS
VIDEO
ANALOG
OUT
AUDIO OUT
V
L
R
Analog signal
L
R
Video signal
V
V
Digital signal
O
(optical)
VIDEO
IN
Digital signal
C
(coaxial)
Signal flow
OPTICAL terminal
Analog terminal.
13