Yamaha HTR-5230RDS Kullanıcı El Kitabı - Sayfa 7

Alıcı Yamaha HTR-5230RDS için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha HTR-5230RDS 50 sayfaları. Natural sound av receiver

Sayfayı Yazdır
q
PHONES jack
Connect the headphones to the PHONES jack. You can
listen to the sound to be output from the main speakers
through the headphones.
When using headphones only, set both SPEAKERS A and B
to the OFF position and press EFFECT to turn off the effect
speakers (center and rear) (so that no DSP program
indicator lights up on the display).
w
SPEAKERS
Set A or B (or both A and B) to the ON position for the main
speaker system (connected to this unit) that you want to use.
Set the button(s) to the OFF position for the main speaker
system that you don't want to use.
e
PROGRAM selector
Press l or h to select a DSP program when the effect
speakers (center, rear and subwoofer) are turned on. The
selected program indicator lights up on the display.
r
EFFECT
Press this button to turn on or off the effect speakers (center
and rear). If you turn them off, all Dolby Digital audio
signals are directed to the right and left main speakers. In
that case, the output levels of the right and left speakers may
not match.
t
Tone controls
These controls are only effective for the sound from the
main speakers.
a) BASS
Turn this control clockwise to increase or counterclockwise
to decrease the low-frequency response. The "0" position
produces a flat response.
b) TREBLE
Turn this control clockwise to increase or counterclockwise
to decrease the high-frequency response. The "0" position
produces a flat response.
y
TAPE/MD MON / EXT. DECODER
Press this button to select a tape or an MD source. The
"TAPE/MD MONITOR" indicator lights up on the display.
When you press the button next, the "TAPE/MD
MONITOR" indicator goes off, "EXT. DECODER" appears
on the display and you can listen to a source connected to
the EXTERNAL DECODER INPUT terminals.
u
BALANCE
This control is only effective for the sound from the main
speakers.
Turn the control to adjust the balance of the output volume
from the right and left main speakers to compensate for
sound imbalance caused by the speaker location or listening
room conditions.
i
A/B/C/D/E
Press this button to select one of a group (A to E) of preset
stations.
o
PRESET/TUNING
When " z " appears
This button is used to select a preset station number (1 to 8).
Press h to select a higher and l to select a lower preset
station number.
When " z " goes off
This button is used for tuning. Press h to tune in to higher
frequencies, and l to tune in to lower frequencies.
When this unit is in the PTY SEEK mode, press this button
to select a program type.
p
PRESET/TUNING, EDIT
Press this button to turn on or off " z " on the display and
switch the function between for storing a broadcasting
station (preset tuning) and for tuning. This button is also
used to exchange the assignment of two preset stations with
each other.
a
FM/AM
Press this button to switch the reception band between FM
and AM.
s
MEMORY (MAN'L/AUTO FM)
Press this button to store the broadcasting stations. Hold
down this button for more than three seconds to begin
automatic preset tuning.
d
TUNING MODE (AUTO/MAN'L MONO)
Press this button to switch the tuning mode between
automatic and manual. To use the automatic tuning method,
press this button so that the "AUTO" indicator lights up on
the display. To use the manual tuning method, press this
button so that the "AUTO" indicator goes off.
CONTROLS AND FUNCTIONS
5