Yamaha R-V703 Kullanıcı El Kitabı - Sayfa 14
Alıcı Yamaha R-V703 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha R-V703 41 sayfaları. Natural sound av receiver
Sayfayı Yazdır
OUTPUT terminals (for driving speakers with external amplifiers)
CENTER OUTPUT terminal
This terminal is for center channel line output. There is no
connection to this terminal when you use the built-in amplifier.
However, if you drive a center speaker with an external power
amplifier, connect the input terminal of the external amplifier to
this terminal.
IMPEDANCE SELECTOR switch
Be sure to switch this only when the power to this unit is not on.
Select the position whose requirements your speaker system
meets.
WARNING
Do not change the IMPEDANCE SELECTOR switch
setting while the power to this unit is on, otherwise
this unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE
STANDBY/ON SWITCH IS PRESSED
The IMPEDANCE SELECTOR switch may not be set to
either end closely. If so, set the switch to either end
closely.
14
OUTPUT
REAR
CENTER
(SURROUND)
SUB
WOOFER
IMPEDANCE SELECTOR
SET BEFORE POWER ON
REAR
6 MIN. /SPEAKER
CENTER
SINGLE:6 MIN. /SPEAKER
DUAL:3 MIN. /SPEAKER
MAIN
A OR B:4 MIN. /SPEAKER
A B:8 MIN. /SPEAKER
REAR
8 MIN. /SPEAKER
CENTER
SINGLE:8 MIN. /SPEAKER
DUAL:4 MIN. /SPEAKER
MAIN
A OR B:8 MIN. /SPEAKER
A B:16 MIN. /SPEAKER
(Europe model)
SUBWOOFER OUTPUT terminal
This terminal is for connecting with the input terminal of an
amplifier for driving a subwoofer.
When the input signals to this unit are in normal 2-channel
stereo, this terminal outputs frequencies below 150 Hz from
the main and center channels. When discrete signals are input
to this unit and are selected as the input source, this terminal
outputs signals from the subwoofer channel.
REAR (SURROUND) OUTPUT terminals
These terminals are for rear channel line output. There is no
connection to these terminals when you use the built-in
amplifier.
However, if you drive rear speakers with an external stereo
power amplifier, connect the input terminals of the external
amplifier (MAIN IN or AUX terminals of a power amplifier or an
integrated amplifier) to these terminals.
Note
Output level of signals from these terminals are adjusted
by the use of VOLUME control on the front panel or VOLUME
keys on the remote control transmitter.
(Upper position)
Rear:
The impedance of each speaker must be 6 or
higher.
Center: If you use one center speaker, the impedance of the
speaker must be 6 or higher.
If you use two center speakers, the impedance of
each speaker must be 3 or higher.
Main:
If you use one pair of main speakers, the impedance
of each speaker must be 4 or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 8 or higher.
(Lower position)
Rear:
The impedance of each speaker must be 8 or
higher.
Center: If you use one center speaker, the impedance of the
speaker must be 8 or higher.
If you use two center speakers, the impedance of
each speaker must be 4 or higher.
<
Main:
Except Canada model
If you use one pair of main speakers, the impedance
of each speaker must be 8 or higher.
If you use two pairs of main speakers, the
impedance of each speaker must be 16 or higher.
<
For Canada model only
The impedance of each speaker must be 8 or
higher.
>
>