Yamaha RX-V671 Kolay Kurulum Kılavuzu - Sayfa 3

Alıcı Yamaha RX-V671 için çevrimiçi göz atın veya pdf Kolay Kurulum Kılavuzu indirin. Yamaha RX-V671 8 sayfaları. Setup guide
Ayrıca Yamaha RX-V671 için: Kolay Kurulum Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Connecting the speakers/subwoofer

• This unit is configured for 8-ohm speakers at the factory. When

connecting 6-ohm speakers, set the speaker impedance of this

unit to "6 Ω MIN". For details, see "Setting the speaker

impedance" (p.16) in "Owner's Manual".

• Use a subwoofer equipped with built-in amplifier.

• Remove the power cable of this unit from an AC wall outlet and

turn off the subwoofer before connecting the speakers.

• Be careful that the core of the speaker cable does not touch

anything or come into contact with the metal areas of this unit.

This may damage this unit or the speakers. If the speaker

cables short circuit, "CHECK SP WIRES" will appear on the

front display when this unit is turned on.

Connecting speaker cables

Speaker cables have two wires. One is for connecting

the negative (-) terminal of the unit and the speaker, and

the other is for the positive (+) terminal. If the wires are

colored to prevent confusion, connect the black wire to

the negative and the other wire to the positive.

Remove approximately

10 mm of insulation from

+ (red)

the ends of the speaker

cable, and twist the bare

wires of the cable

together firmly.

– (black)

Loosen the speaker

terminal.

Insert the bare wires of the cable into the gap on the

side (upper right or bottom left) of the terminal.

Tighten the terminal.

Using a banana plug

Tighten the speaker

terminal.

Banana plug

Insert a banana plug into

the end of the terminal.

Connect the front speakers (

to the FRONT (

This unit (rear)

FRONT

F R

O N

F R

O N

)

) terminals.

SPEAKERS

CENTER

SURROUND

SURROUND BACK/BI–AMP

SINGLE

EXTRA SP

ZONE 2/

PRESENCE

SUBWOOFER

Connect the center speaker (

CENTER terminal.