Yamaha A-S300 Kullanıcı El Kitabı - Sayfa 8
Amplifikatör Yamaha A-S300 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha A-S300 38 sayfaları. Integrated amplifier
Ayrıca Yamaha A-S300 için: Kullanıcı El Kitabı (42 sayfalar), Kullanıcı El Kitabı (22 sayfalar), Kullanıcı El Kitabı (20 sayfalar)
Sayfayı Yazdır
CONNECTIONS
CAUTION
• The IMPEDANCE SELECTOR switch must be set to the appropriate position before connecting speaker sets. See
page 4 for details.
• Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the
speakers.
• Do not connect this unit or other components to the main power until all connections between components are
complete.
1
Remove approximately 10 mm (3/8 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
10 mm (3/8 in)
2
Connect the speaker cable.
1 Unscrew the knob.
2 Insert one bare wire into the hole in the side
of each terminal.
3 Tighten the knob to secure the wire.
■ Connecting via banana plug
(Except for Asia, U.K. and Europe
models)
Tighten the knob and then insert the banana plug into the
end of the corresponding terminal.
Banana plug
6
En
Red: positive (+)
Black: negative (–)
■ Bi-wire connection
Bi-wire connection separates the woofer from the
combined midrange and tweeter section. A bi-wire
compatible speaker has four binding post terminals. These
two sets of terminals allow the speaker to be split into two
independent sections. With these connections, the mid and
high frequency drivers are connected to one set of
terminals and the low frequency driver to another set of
terminals.
This unit
Connect the other speaker to the other set of terminals in
the same way.
CAUTION
When making bi-wire connections, set the IMPEDANCE
SELECTOR switch to HIGH or LOW depending on the
impedance of your speakers:
6 Ω or higher: HIGH (Taiwan and Central/South
America models)
8 Ω or higher: HIGH (Asia model)
4 Ω or higher: LOW
See page 4 for more information about the IMPEDANCE
SELECTOR switch.
Note
When making bi-wire connections, remove the shorting bridges
or cables on the speaker.
y
To use the bi-wire connections, switch the SPEAKERS selector
to the A+B position.
Speaker