Yamaha AG-Stomp Kullanıcı El Kitabı - Sayfa 15

Amplifikatör Yamaha AG-Stomp için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha AG-Stomp 32 sayfaları. Yamaha accoustic guitar/pre-amplifier owner's manual
Ayrıca Yamaha AG-Stomp için: Servis Kılavuzu (45 sayfalar), Yama Listesi (1 sayfalar), (Felemenkçe) El Kitabı (32 sayfalar)

Sayfayı Yazdır

G Setting the Mic Simulator

The Mic Simulator is a specially designed circuit that adds to an electric/acoustic guitar, the special charac-

teristics created when miking an acoustic guitar. It adds the airiness, which is found when a microphone is

placed in front of the guitar's sound hole. The Mic Simulator is useful when your guitar is connected directly

to a mixer or recorder via a line, or when listened to through a pair of headphones for practice, etc.

The AG-Stomp provides the eight different Mic Simulator settings described below. The Mic Simulator creates a

stereo image by simulating two microphones positioned in front of the guitar but "aimed" at dif ferent angles

toward the guitar. Use the MIC TYPE Select Switch to try out some of the different microphone simulation types.

The BLEND knob is used to adjust the volume balance between the signal after it has passed through the Mic

Simulator (MIC tone) and the signal before it has passed through the Mic Simulator (DIRECT tone). Rotate the

knob fully to the left to hear only the DIRECT tone. Rotate the knob fully to the right to hear only the MIC tone.

Also, pressing the [SHIFT] button to enter the SHIFT mode (the SHIFT lamp flashes) lets you use the

BLEND (stereo) knob to adjust spaciousness of the sound produced by the Mic Simulator's two micro-

phones. Press the [SHIFT] button again to exit the SHIFT mode and the lamp will turn off.

* In the SHIFT mode, if a knob is not rotated after five seconds, the mode will be exited automatically.

Simulates microphones positioned

close to the guitar.

Micro-

phone

MIC TYPE Select

Switch Position

CONDENSER 1

CONDENSER 2

DYNAMIC 1

DYNAMIC 2

TUBE 1

TUBE 2

NYLON STR 1

NYLON STR 2

* Mic Simulator settings are stored in patch data (MIC TYPE Select Switch Settings).

* When the Volume and Tone controls are set to high, the signal may clip inside of the AG-Stomp. In this case, decrease the guitar's

volume, or adjust the AG-Stomp's VOLUME, individual Tone Controls or individual Effect knobs. Also, if feedback occurs, please

use the Feedback Reduction Function described on page 16.

Micro-

phone

Display

Description of the Simulation

Simulates the characteristics associated with a condenser mic

C-1

positioned close to the acoustic guitar.

Simulates the characteristics associated with a condenser mic

C-2

positioned far from the acoustic guitar. Room sound is also present.

Simulates the characteristics associated with a dynamic mic

d-1

positioned close to the acoustic guitar.

Simulates the characteristics associated with a dynamic mic

d-2

positioned far from the acoustic guitar. Room sound is also present.

Simulates the characteristics associated with a tube mic positioned

t-1

close to the acoustic guitar.

Simulates the characteristics associated with a tube mic positioned

t-2

far from the acoustic guitar. Room sound is also present.

Simulates the characteristics associated with a nylon string guitar

n-1

with a condenser mic positioned close to the guitar.

Simulates the characteristics associated with a nylon string guitar with a

n-2

condenser mic positioned far from the guitar. Room sound is also present.

Using the AG-Stomp

Simulates microphones positioned

far from the guitar.

Micro-

phone

Micro-

phone