Yamaha AX-1070/870 Kullanıcı El Kitabı - Sayfa 13
Amplifikatör Yamaha AX-1070/870 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha AX-1070/870 16 sayfaları. Natural sound stereo integrated amplifier
Sayfayı Yazdır
STANDBY mode
(For Europe model only)
While the power is on, pressing the POWER key on the remote
control transmitter switches the unit to the STANDBY mode.
(In this mode, the indicator is half illuminated.)
Note
To turn the power off completely, disconnect the AC
power plug from the wall outlet.
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation
1
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
Use only AA, R6, UM-3 batteries for replacement.
Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
3
2
POWER on mode
Remote control transmitter operation range
Remote control
sensor
Notes
There should be no large obstacles between the remote
control transmitter and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
STANDBY mode
Within approximately
7 m (23 feet)
13