Yamaha BBT500-110 Kullanıcı El Kitabı - Sayfa 10
Amplifikatör Yamaha BBT500-110 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha BBT500-110 21 sayfaları. Yamaha bass amplifier owner's manual
Sayfayı YazdırPanel Controls and Connections
* Total Impedance
Whenever two or more speaker cabinets are connected to the unit, consideration must be given to the total impedance of the
speaker system.
Normally, a speaker cabinet has an impedance of 4, 8 or 16Ω. But when two or more speaker cabinets are used together, the total
impedance will change according to the manner in which the cabinets are connected.
● Connecting in a Series
Total impedance = 1st Speaker + 2nd Speaker + 3rd Speaker ...
Connecting three 4Ω speaker cabinets in a series as shown below,
results in a total impedance of 12Ω.
● Connected in Parallel
Total impedance =
Connecting three 4Ω speaker cabinets in a parallel configuration
as shown below, results in a total impedance of about 1.3Ω.
4
● Attaching the Clamp Filter
To protect against electromagnetic waves, attach the supplied Clamp Filter to the cable connecting the bass guitar to the amplifier's
INPUT jack, and to the cable connecting the amplifier to an external speaker.
* The cable connecting the internal speaker (SPEAKER 1 jack) is fitted with a Clamp Filter at the factory.
* When attaching the clamp filter, wrap the cable once around the clamp filter as close to the BBT500 unit as possible.
10
4
4
(For U.S. and Canadian models only)
Clamp Filter
As the BBT500-115's and BBT500-110's two speaker jacks are
connected in a parallel circuit inside of the amplifier, adding a 4Ω
external speaker to the 4Ω internal speaker will result in a total
impedance of 2Ω. So in order to maintain a minimum impedance of
2Ω, an external speaker with an impedance of 4Ω or greater must
be used.
External Speaker
Greater than 4 Ω
Cable
Clamp Filter
Internal Speaker
4 Ω