Yamaha KMA-700 Kullanıcı El Kitabı - Sayfa 15

Amplifikatör Yamaha KMA-700 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha KMA-700 23 sayfaları. Digital karaoke mixing amplifier

Sayfayı Yazdır
Yamaha KMA-700 Kullanıcı El Kitabı
■ Names of parts and their functions
1 INPUT
INPUT is not available in default setting.
To activate INPUT, refer to "Input mode" on page 14.
2 KEY CONTROL (
Transpose the key of the played music.
3 MIC (
/
)*
Adjust the overall volume of the microphones.
4 ECHO (
/
)*
Adjust the amount of echo.
5 MUSIC (
/
)*
Adjust the music volume.
* The LED on the corresponding control on the front panel blinks
during adjustment.
6 PRESET (1/2/3)
Recall saved preset settings for MIC volume/ECHO
amount/MUSIC volume/ECHO MODE.
To save current settings of the above, press the desired
button (PRESET 1, 2, 3 or KEY CONTROL on the front
panel) for 3 seconds. Pressing KEY CONTROL saves
settings to PRESET 1. When save is completed, " " on
the KEY CONTROL blinks once. You can save up to 3
presets (PRESET 1/2/3) on this unit. Refer to "Power ON
recall" on page 14.
7 ECHO MODE
Select NORMAL, WIDE or SPACIOUS (KMA-700 only)
echo.

REMOTE CONTROL

/ /
)
■ Preparing the remote control
The remote control comes with the battery already
installed. Before using the remote control for the very first
time, pull out the plastic tab, as shown.
For information on replacing the battery, refer to next
section.
■ Operation of remote control
1. Remote control
The distance between the remote control and the remote
sensor of this unit should be within 6 m (20'). Be sure to
aim the remote control directly at the remote sensor on the
front panel.
2. Loading a battery
The life of the battery used in the remote control is about
half a year under normal use. Remove the battery if the
remote control is not used for an extended period. When
the battery becomes weak, replace with a new CR2025
battery.
To replace the battery:
1. Using a small screwdriver, carefully slide out the
battery holder.
2. Remove the expired battery, and place the new
CR2025 battery onto the battery holder with the + side
facing up.
3. Slide the battery holder into the remote control, and
push it so that it clicks shut.
+ side up
Plastic tab
Within 6 m
(20')
30°
30°
11
En