Yamaha M-2 Kullanıcı El Kitabı - Sayfa 6

Amplifikatör Yamaha M-2 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha M-2 12 sayfaları. Stereo power amplifier
Ayrıca Yamaha M-2 için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (13 sayfalar), Servis Kılavuzu (26 sayfalar)

Sayfayı Yazdır

FRONT

PANEL

AND

CONTROLS

NATURAL

SIEREQ

POWER p^

₪5

GO POWER" switch)

When

this button

is depressed, power to the unit

will be switched on and the switch will light up.

When depressed again, power is turned off.

₪ Due to the action of the muting

relay, no

sound

will be heard for several seconds after

switching

the

power.

This

prevents

any

transient

switching

noises

from

reaching

the

speakers.

W Be sure to turn down

the VOLUME

control

on the control

amplifier to minimum

before

turning on

the POWER

switch to guard the

speakers

against

any

sudden

loud

program

sounds produced after the muting relay time.

mm enne

SPEAKER

PEAK

OUTPUT

LEVEL

O SPEAKERSI(A and B)

These

two

push-button

switches govern the two

speaker

terminals

A and B. When

depressed, the

speaker

set connected to the respective terminal

will be connected

and the switch

will light up.

Depressing

the switch

again will disconnect

the

speakers.

When

using

both

terminals

at the

same

time,

refer to "Speaker

Connections"

(p. 7) regarding

speaker impedance.

The

SPEAKER

switches

should

be turned

off

when

changing

the

connection

of the

speaker

cords, and they can be used in other cases, such

as changing program sources etc., as well.

D.‫‏‬

‫ו ו‬

‫ן ו‬

. .

‫ה‬

‫פ‬

‫ש‬

‫ה‬

4 0

৩" 101000010000000000, 0

@ PEAK

OUTPUT

LEVEL

(PEAK

and OVERLOAD

INDICATOR)

These

peak indicators provide visual indication of

the left and right output levels. They cover a range

of 0.002W to 400W (89) (—50dB to 3dB).

Note:

Also

that the meters are calibrated accu-

rately for output power into standard 2

speakers,

but

that

corrections

must

applied

if speakers with

different imped-

ance are used.

Clipping

(at about 2% THD)

is indicated for the

left and

right outputs

separately by the OVER-

LOAD

indicators. When these light up, turn down

the input level by using the LEVEL

controls on

the rear panel.