Yamaha XDA-AMP5400 Kullanıcı El Kitabı - Sayfa 5

Amplifikatör Yamaha XDA-AMP5400 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha XDA-AMP5400 44 sayfaları. Multi zone amplifier

Sayfayı Yazdır

Rear panel

a GND screw terminal

Connecting the source device chassis to the GND terminal of the

unit may reduce noise in the signal.

Note

The ground is not a safety ground.

b IR IN/OUT jack

Connection: 3.5 mm monaural mini-plug

For connecting to an external remote control device and

inputting/outputting remote control signals. The output with pass-

through function is enabled even in standby mode.

c AMP 1– 4: IN/THRU. OUT jacks

Connection: stereo RCA plug (L/R)

IN: For connecting to an audio playback device such as a CD

player (analog out jack) and inputting audio signals in AMP1–

AMP4.

THRU. OUT: For outputting analog audio signals input in

AMP 1– 4 : IN jacks by pass-through function. The output is

enabled even in standby mode.

d AUTO STANDBY switch

Enables/disables the auto-standby function.

OFF: does not set the unit to standby mode automatically.

ON: sets the unit to standby mode when there are no operations

for 8 hours.

AUDIO SENSE switch

Enables/disables the audio sense function that detects analog

audio signals input in AMP 1– 4 : IN.

OFF: disables the audio sense function.

ON: detects the input in AMP 1– 4 : IN, and thereby turns

AMP1– AMP4 to on.

Note

Unplug the unit's power cord from the AC wall outlet before

changing the AUDIO SENSE switch setting.

AUDIO SENSE MODE switch

Selects the audio sense mode that determines the amount of

time required between input of analog audio signals being

detected and analog audio signals being output.

STANDBY: outputs analog audio signals about 7 seconds after

detecting the input of them. This setting reduces the unit's

standby power consumption..

ACTIVE: outputs analog audio signals within 1 second after

detecting the input of them.

e TRIGGER IN 1– 4 jacks

Connection: 3.5 mm monaural mini-plug (Tip: + / Sleeve: -)

For inputting trigger signals (DC 12 V). Each AMP is powered on

by inputting "High".

f TRIGGER OUT 1– 4 jacks

Connection: 3.5 mm monaural mini-plug (Tip: + / Sleeve: -)

For outputting trigger signals (DC 12 V) iby powering on each

AMP.

g NORMAL/BRIDGE switch

Selects NORMAL/BRIDGE connection of speakers. This switch

is normally set to NORMAL. Change the setting to BRIDGE only

when the speaker is used in bridge connection.

Note

Unplug the unit's power cord from the AC wall outlet before

changing the NORMAL/BRIDGE switch setting.

h SPEAKERS terminals

Connection: Euroblock connectors (supplied)

Speaker impedance: 4 Ω or over (NORMAL), 8 Ω or over

(BRIDGE)

For connecting to speakers with supplied Euroblock connectors.

i AC IN jack

For connecting the supplied power cord.

En 5