Yamaha XMV8280-D Kullanıcı El Kitabı - Sayfa 11

Amplifikatör Yamaha XMV8280-D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha XMV8280-D 42 sayfaları. Ferrite cores
Ayrıca Yamaha XMV8280-D için: Kullanıcı El Kitabı (42 sayfalar), Kullanıcı El Kitabı (42 sayfalar), Kullanıcı El Kitabı (39 sayfalar), Kullanım Kılavuzu (2 sayfalar)

Sayfayı Yazdır

!4 [PRIMARY]/[SECONDARY] indicators

(XMV8280-D/XMV8140-D only)

These show the communication status of the Dante [PRI-

MARY]/[SECONDARY] connectors @1 . They flash rapidly

in green if the Ethernet cables are connected properly.

!5 [SYNC] Indicators

(XMV8280-D/XMV8140-D only)

These show the operating status of the Dante network. If the

green (upper) indicator lights, the unit is operating as a word

clock slave and synchronizing to the word clock. If the green

indicator flashes, the unit is operating as the word clock mas-

ter. If the power to the unit is turned on but the green indica-

tor is turned off, the unit is not functioning properly. In this

case, refer to the "Warning Messages" section (see page 29).

If the orange indicator lights or flashes, refer to the "Warning

Messages" section.

!6 [PANEL LOCK] indicator

This lights or flashes according to the state of the front panel

lock. To specify the front panel lock setting, use the Device

setup DIP switch @3 .

Indicator

Front panel operations are locked. Lock

will be temporarily defeated if you press

Lit

the [FUNCTION] button !7 and the

[SELECT] A button t.

Unlit

Front panel operations are not locked.

Lock is temporarily defeated. When the

Flashing

XMV is restarted, it will be in a locked

state.

!7 [FUNCTION] button

Use this to check or change the operating mode of the

XMV's front panel. For details on how to perform front

panel operations, refer to "Front Panel Operations" (page

23).

!8 Cooling vent

Located behind the vent is a variable speed cooling fan that

draws air in from the front and exhausts it through the rear.

The fan speed will automatically vary according to the tem-

perature.

Please be sure that you do not block the air intakes or

exhaust vents. You should also clean the air intakes and

exhaust vents regularly. If the air intakes are clogged with

dust or debris, the unit will overheat, which may result in the

unit shutting down.

Status

XMV8280/XMV8140/XMV8280-D/XMV8140-D Owner's Manual

Controls and Functions