Yamaha DBR Series Kullanıcı El Kitabı - Sayfa 4

Hoparlör Sistemi Yamaha DBR Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha DBR Series 10 sayfaları.

CAUTION

• Before doing any installation or construction work, consult with your Yamaha dealer.

• For optimum safety, the installation should be checked thoroughly at regular intervals. Some fittings may deteriorate

over extended periods of time due to wear and/or corrosion.

• When choosing the installation location, suspension wire and mounting hardware, make sure all are strong enough to

support the weight of the speaker.

• Make sure to take measures to prevent the speaker from falling down in the event of a installation failure.

• When installing the safety wire to the wall, install it higher than the wire's attachment point on the speaker, with as little

slack as possible. If the wire is too long, and the speaker happens to fall, the wire may snap as a result of too much

strain.

Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support

structure or improper installation.

Installation using separately sold Yamaha speaker

brackets

Attach the bracket to two screw holes at the bottom of the unit using commercially available screws

(M8 x 16 mm) or eye bolts (M8 x 15 mm). For details on installing the bracket, refer to the corresponding

manual.

❚

Using the BWS251-300 or BWS251-400 wall mounting

bracket

Maximum tilt

angle

❚

Using the BCS251 ceiling bracket

The tilt angle depends on the position relation between the speaker

and the wall. The maximum downward tilt angle is shown in the

following chart.

Maximum tilt angle

DBR15

DBR12

DBR10

Max. 45°

Installation E

BWS251-300

BWS251-400

8°

11°

20°

(Pullback point for DBR15

and DBR12 only)

17.5°

23°

35°