Yamaha DSP-E200 Kullanıcı El Kitabı - Sayfa 17
Hoparlör Sistemi Yamaha DSP-E200 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha DSP-E200 19 sayfaları. Natural sound digital sound field processor
Sayfayı Yazdır
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation
3
2
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
Use only AA, R6, UM-3 batteries for replacement.
Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact with
clothing, etc. Clean the battery compartment thoroughly
before installing new batteries.
SPECIFICATIONS
Minimum RMS Output Power per Channel
Center (8 ohms, 20 Hz – 20 kHz, 0.08% THD)
..........................................................................................25W
Rear L, R (8 ohms, 1 kHz, 0.3% THD) ...................25W+25W
Input Sensitivity/Impedance
INPUT.........................................................150 mV/47 k-ohms
Output Level/Impedance
MAIN OUT/CENTER OUT....................................1V/1 k-ohms
Frequency Response (20 Hz to 20 kHz)
INPUT to MAIN OUT..................................................0±0.5 dB
Total Harmonic Distortion (20 Hz to 20 kHz)
INPUT to MAIN OUT (1 V) .............................................0.01%
Signal-to-Noise Ratio (IHF-A Network)
MAIN OUT (Input Shorted)..............................................95 dB
Residual Noise (IHF-A Network)
MAIN OUT.........................................................................5 µV
Channel Separation
(Input 5.1 k-ohms Shorted 1 kHz/10 kHz) ...............65 dB/50 dB
1
Remote-control transmitter operation range
Remote-control
sensor
Notes
There should be no large obstacles between the remote
control transmitter and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter not to work
correctly. In this case, reposition the main unit to avoid
direct lighting.
Power Supply
[U.S.A. and Canada models] .......................AC 120 V, 60 Hz
[Australia and U.K. models] .........................AC 240 V, 50 Hz
[Europe model] ............................................AC 230 V, 50 Hz
[General model] ..................AC 110/120/220/240V, 50/60 Hz
Power Consumption ............................................................90W
AC Outlet
1 UNSWITCHED OUTLET ...........................200W max. total
Dimensions (W x H x D) .......................435 x 151.3 x 296.7 mm
Weight ......................................................7.7 kg (16 lbs. 15 oz.)
Accessories ......................................Remote control transmitter
Specifications subject to change without notice.
Within approximately
7 m (23 feet)
(17-1/8" x 5-15/16" x 11-11/16")
Batteries
Audio connection cord x 2
17