Yamaha DZR10 Kullanıcı El Kitabı - Sayfa 5

Hoparlör Sistemi Yamaha DZR10 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha DZR10 31 sayfaları. Powered loudspeakers/subwoofer
Ayrıca Yamaha DZR10 için: Kullanıcı El Kitabı (31 sayfalar), Kullanıcı El Kitabı (31 sayfalar), Kullanıcı El Kitabı (31 sayfalar)

Sayfayı Yazdır

• When transporting or moving the product, always use two or

more people. Attempting to lift the product by yourself may

damage your back, result in other injury, or cause damage to

the product itself.

• Do not use the speaker's handles for suspended installation.

Doing so can result in damage or injury.

• Do not hold the bottom of the product when transporting or

moving it. In doing so, you may pinch your hands under the

product, and result in injury.

• Do not press the rear panel of the product against the wall.

Doing so may cause the plug to come in contact with the wall

and detach from the power cord, resulting in short circuiting,

malfunction, or even fire.

• If you use the pole socket for mounting a satellite speaker

using a speaker pole, carefully read the section "r Dual pole

sockets" on page 7. Use of any other size pole may cause the

product to fall, and result in injury or damage to the internal

components.

• Always consult qualified Yamaha service personnel if the

product installation requires construction work, and make

sure to observe the following precautions.

- Choose mounting hardware and an installation location that

can support the weight of the product.

- Avoid locations that are exposed to constant vibration.

- Use the required tools to install the product.

- Inspect the product periodically.

Maintenance

• Remove the power plug from the AC outlet when cleaning the

product.

Handling caution

• Do not insert your fingers or hands in any gaps or openings

on the product (vents, ports, etc.).

• Do not operate the product if the sound is distorting.

Prolonged use in this condition could cause overheating and

result in fire.

Yamaha cannot be held responsible for damage caused by

improper use or modifications to the product, or data that is

lost or destroyed.

NOTICE

To avoid the possibility of malfunction/damage to the product,

damage to data, or damage to other property, follow the notices

below.

 Handling and maintenance

• Do not use the product in the vicinity of a TV, radio, AV

equipment, mobile phone, or other electric products. Oth-

erwise, the product, TV, or radio may generate noise.

• Do not expose the product to excessive dust or vibration,

or extreme cold or heat (such as in direct sunlight, near a

heater, or in a car during the day), in order to prevent the

possibility of panel disfiguration, unstable operation, or

damage to the internal components.

• Condensation can occur in the product due to rapid, dras-

tic changes in ambient temperature—when the product is

moved from one location to another, or air conditioning is

turned on or off, for example. Using the product while con-

densation is present can cause damage. If there is reason

to believe that condensation might have occurred, leave

the product for several hours without turning on the power

until the condensation has completely dried out.

• Do not place the speaker face down with the grille

attached, as deformation of the grille may result.

• When placing the speaker face down, always place it on a

flat surface.

• Do not touch the speaker driver unit.

• Air blowing out of the bass reflex ports is normal, and often

occurs when the speaker is handling program material

with heavy bass content.

• During extreme changes in temperature or humidity, con-

densation may occur and water may collect on the surface

of the product. If water is left, the wooden parts may

absorb the water and be damaged. Make sure to wipe any

water off immediately with a soft cloth.

 Connectors

• XLR-type connectors are wired as follows (IEC60268 stan-

dard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-).

Information

 About functions/data bundled with the prod-

uct

• This product uses Dante Ultimo. Refer to the Audinate

website (English) for details on the open‐source licenses

for the particular software.

https://www.audinate.com/software-licensing

 About this manual

• The illustrations and LCD screens as shown in this manual

are for instructional purposes only.

• The bitmap fonts used in this instrument have been pro-

vided by and are the property of Ricoh Co., Ltd.

• The company names and product names in this manual

are the trademarks or registered trademarks of their

respective companies.

• Software may be revised and updated without prior notice.

 About disposal

• This product contains recyclable components. When dis-

posing of this product, please contact the appropriate

local authorities.

PA_en_9 2/2