Yamaha HS8S Kullanıcı El Kitabı - Sayfa 8

Hoparlör Sistemi Yamaha HS8S için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha HS8S 20 sayfaları. Serie hs monitor da studio alimentato e subwoofer alimentato
Ayrıca Yamaha HS8S için: Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (21 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), Kullanıcı El Kitabı (20 sayfalar), (İngilizce) Kullanım Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Setup

In this section we'll look at the general procedure for connecting and setting up a monitor speaker system.

This is just an example though, so feel free to set up your own system in the way that best serves your

personal listening needs.

Cables

You'll need to acquire appropriate cables to connect

the HS series monitor speakers to your audio interface

or other source equipment.

• Short, hi h-quality cables

Use high-quality cables of the shortest practical

length. The longer the cable, the more chance there

is that noise will creep in to degrade your sound.

• Balanced cables

Balanced cables are more resistant to noise than

unbalanced cables. If you have to use unbalanced

cables because the source equipment only has

unbalanced outputs, be sure to use the shortest

possible unbalanced cables.

Connections

NOTICE

Plug the supplied AC power cord into the corresponding socket on the

speaker. Plug the power cord into the speaker first, and then insert the

AC plug end into an appropriate AC wall outlet.

Connectin to an Audio Interface

When connecting an audio interface (Steinberg UR or

AXR series, etc.) to HS series speakers, connect the

audio interface output connectors directly to the

speakers' input connectors. Normally you'll connect to

the LINE OUT 1 and 2 (1L and 2R outputs), although

that might depend on the specific audio interface and

DAW (Digital Audio Workstation) settings used.

HS /HS7/HS5

HS8/HS7/HS5/HS8I/HS7I/HS5I/HS8S Owner's Manual

HS /HS7/HS5

 Recommended cables

 For connection to a balanced phone jack input.

 For connection to an unbalanced phone jack input.

NOTE Refer to "Connectable cables" on page 5 for more connector

details. The configurations of the balanced and unbalanced

phone jack connectors are different.

Connectin to a Mixer

When connecting a mixer (Yamaha MGP or MG series,

etc.) to HS series speakers, connect the mixer's

MONITOR OUT or C-R OUT (Control Room) connectors

directly to the speakers' input connectors. This makes it

possible to control the monitor level independently from

the mixer's main bus level.

HS /HS7/HS5

INPUT

MONITOR

OUT

C-R OUT

HS /HS7/HS5

INPUT