Caliber RCD 272DBTI Manuel - Sayfa 15
Araç Alıcısı Caliber RCD 272DBTI için çevrimiçi göz atın veya pdf Manuel indirin. Caliber RCD 272DBTI 19 sayfaları.
Sayfayı Yazdır
RCD 272DBTi MANUAL
INSTALLATION GUIDE
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below. The
dashboard should be 4.75mm - 5.56mm thick
in order to be able to support the unit.
as necessary until the sleeve easily slides into
the opening. Do not force the sleeve into the
opening or cause it to bend or bow. Check for
unit chassis.
Reset
Press the RESET button with a pointed object
to reset the unit to the original status.
Note: Press the RESET button will erase the
clock setting and stored stations.
16
Installation Procedures
1. If relevant, remove any other audio system
from the car.
2. Insert the mounting sleeve into the
down the metal tabs.
3. P e r f o r m t h e r e q u i r e d e l e c t r i c a l
connections.
4. Then check that everything works before
installing the main unit.
5. Remove the two screws on the top of the
unit, otherwise, the unit will not work.
6. Install the car radio in the dashboard using
the supplied screws (M5x6mm).
7. Attach the outer trim frame.
If you are not sure how to install this unit
Remove the
two screws
Mounting sleev e
Main unit
Trim plate
ANTI-THEFT SYSTEM
This unit is equipped with a detachable panel.
Removing this panel makes the radio totally
inoperable.
Remove the detachable panel
1. Switch o the power of
the unit.
2. Press
down the panel.
3. Hold the right part of the panel. Press to
the left side, then take o the panel.
4. Place the panel into the case and take it
with you when you leave the car.
Install the panel
1. Hold the panel and
ensure the panel faces
downward, and set left
side of the panel in the
panel bracket, then set
the right part.
2. Press the top of panel until it locks.
Remove the unit
1. Remove the panel and
the trim plate.
2. Insert both T-Keys
into hole on the front of
the set until they lock.
3. Pull out the unit.
1
2