Directed 1-button series Kurulum Kılavuzu - Sayfa 8

Uzaktan Çalıştırıcı Directed 1-button series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed 1-button series 20 sayfaları. Keyless entry remote start 4113, 1-button series

Sayfayı Yazdır

Neutral safety switch interface

Some vehicles do not have an electrical neutral safety switch, but instead have a mechanical neutral safety

switch that interrupts the starter wire when the vehicle is in any drive gear. The remote start must be interfaced

before the neutral safety switch , to provide protection from starting in gear. However, some vehicles combine

the column shift and the neutral safety switch into one mechanical part, and in this case you will not be able

to interface the remote start before the neutral safety switch.

Important: You must complete the remote start system installation before doing the follow-

ing test. Ensure that the remote start system is functioning normally. This includes connect-

ing to the brake as a shut-down.

Testing the neutral safety switch

1. Make sure there is adequate clearance to the front and rear of the vehicle because it may move slightly.

2. Make sure the hood is closed and there are no remote start shut-downs active.

3. Set the emergency brake.

4. Turn the key to the "run" position, this releases the shifter.

5. Place the car in drive (D).

6. Place your foot directly over the brake pedal, but do not depress it. Be ready to step on the brake if the

starter engages.

7. Activate the remote start system.

8. If the starter engages, immediately depress the brake to shut the remote start system down. If the

starter does not engage, no additional safety

system is required.

If the starter engages and the vehicle is a General Motors product or Dodge Dakota pickup, refer to

www.

for Document 1008 under the Resource tab. For an alternative shut-down method

directechs.com

which prevents the starter from engaging. If the vehicle is not a General Motors product or a Dodge

Dakota pickup, please call Directed Electronics Technical Support for an alternative shut-down method.

Do not return the vehicle to the customer until this feature is properly installed!