ALDI FERREX 704518 Kullanıcı Kılavuzu - Sayfa 18
Testere ALDI FERREX 704518 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ALDI FERREX 704518 20 sayfaları. 1010w
Sayfayı Yazdır
1010W Belt Sander
Troubleshooting
Symptom
Product does not
start
Product does not
reach full power
The sanding
belt is not in the
centre of the
base plate during
operation
For further inquiries or issues associated with your 1010W Belt Sander, call our
Customer Service on 1300 889 028 or email us at
15
e-mail: [email protected]
MODEL No.: PBS101.A • 02/2021 • 704518
Possible causes
1.1 Not connected to
power supply
1.2 Product not switched on.
1.3 Power cord or plug is
defective
1.4 Other electrical defect
to the product
2.1 Extension cord not
suitable for operation with
the product
2.2 Power source has too
low voltage
3.1 Fail to adjust the sanding
belt with the belt adjustment
control.
3.2 Sanding belt deformation
due to the long time use.
Solution
1.1 Connect to power supply
1.2 Press the on/off trigger
then lock on button.
1.3 Contact customer service
1.4 Contact customer service
2.1 Use a proper extension
cord
2.2 Connect to another power
source
3.1 Adjust the sanding belt as
described in the chapter" Belt
adjustment control".
3.2 Replace a new sanding belt.
AFTER SALES SUPPORT
1300 889 028
(toll free)