Clarke 3120110 Kullanım ve Bakım Talimatları - Sayfa 9

Elektrikli Alet Clarke 3120110 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Talimatları indirin. Clarke 3120110 17 sayfaları. Ratchet wrench

OPERATION

WARNING: ALWAYS WAIT UNTIL THE DRIVE SHAFT HAS STOPPED ROTATING

BEFORE SETTING THE DIRECTION CONTROL.

To select the direction of rotation turn

the direction control as follows.

• For tightening bolts/nuts, turn

the direction control anti-

clockwise to F (Forward).

• For loosening bolts/nuts, turn the

direction control clockwise to R

(Reverse).

FITTING SOCKETS AND USING THE AIR RATCHET

IMPORTANT: Only use sockets designed for use with a ratchet wrench;-

either 3/8" (10mm) for the CAT109 or 1/2" (13mm) for the CAT108.

1. Select the socket you require and

push it onto the square drive shaft.

• It clicks into place when secure.

2. Place the socket over the nut.

• Take care that the socket is

firmly engaged.

3. Squeeze the trigger against the

body of the tool to start.

4. Release the trigger to stop the tool.

5. ALWAYS ensure the tool has stopped before putting it down.

6. When releasing very tight fastenings initially break loose by hand. Squeeze

the trigger and the air tool will complete the job.

7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.

8. When assembling, start turning fasteners by hand, then set the rotation

forward or reverse. Apply the tool gently and squeeze the trigger to tighten

with power.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]